badbacks 3Dee Assembly Manual

Assembly Guide

Questions? Ask us!

aeris-Impulsmöbel GmbH & Co. KG, Ahrntaler Platz 2-6, 85540 Haar by Munich

Phone.: +49 (0) 89/900506-0, [email protected], www.aeris.de

Important Information

Congratulations on the purchase of your 3

Dee active office chair. Please read the following important information for chair assembly.

1. Instructions for Use and Assembly

The use and assembly instructions are in a compartment on the inside of the

backrest. Please remove the instructions and read them BEFORE assembly and use

of your 3

Dee active office chair.

2. Assembly For assembly, make sure you use a suitable underlay to prevent scratching of the high-

quality surfaces.

1) Slot all the castors into the upturned base.

Turn the base over and set it on the floor.

2) Loosely insert the spring strut into the large opening of the base. Hold the rubber con-

necting joint and slowly turn the spring strut until you feel and hear it fall into place in the

base. Now firmly press down the spring strut.

3.1) Now take the seat and place the seat opening on the gas spring.

3.2) Hold the spring strut with one hand and with the other hand slowly

turn the seat until you feel it fall into place.

3.3) IMPORTANT: Check after the seat has fallen into place whether the

two white arrows on the gas spring and on the opening of the seat are fac-

ing each other.

Now sit on the seat and bounce up and down forcefully a few times so

that the conical connections can no longer separate.

4) Slot the backrest into the appropriate opening under the seat. Use your hand or foot to

ensure that the chair does not roll away. You must slot the backrest slowly and perfectly

straight into the opening until you hear it click into place and you can no longer pull it

out.

www.badbacks.com.au

FreeCall 1800 615 666 Phone 03 9699 8851 Fax 03 9699 3880 Email

Bad Backs Head Oce - 79 Overseas Drive Noble Park 3174