Pass and Seymour 880 Operating instructions

Pass and Seymour
Brand
Pass and Seymour
Model
880
Type
Operating instructions

This manual is also suitable for

Walkerbox
®
Brass Floor Box Covers
Cat. Nos. 895SP and 895TSP
INSTALLATION INSTRUCTIONS
Walker
®
electrical systems conform to
and should be properly grounded in com-
pliance with requirements of the current
National Electrical Code or codes admin-
istered by local authorities.
All electrical products may present a
possible shock or fire hazard if improperly
installed or used. Walker electrical prod-
ucts may bear the mark as UL Listed
and/or Classified and should be installed
in conformance with current local and/or
the National Electrical Code.
1. Locate the outlet box and
remove the top protector cap.
2. Pull necessary wires, following
the National Electrical Code
and/or local codes.
3. If using a box with adjusting
screws, adjust the floor plate
to the proper height.
4. Apply a bead of acrylic latex
around the box, sealing the
opening between the box
and the adjacent concrete.
5. Install a listed duplex wiring
device (not supplied by Walker),
the fill-in plate, and gasket.
6. Attach the floor cover (895SP or
895TSP) using the brass screws
provided. Fasten securely.
7. Install the screw plugs when
receptacle is not in use.
Carpet or Tile Trim to Fit
Inner Edge of Floor Plate Ring
1 1/2" [38mm]
Screw Plug
Walker Systems, Inc.
1000 Innovation Drive, Williamstown, WV 26187
IA0149 0800
© Copyright 2000 The Wiremold Company All Rights Reserved
  • Page 1 1

Pass and Seymour 880 Operating instructions

Pass and Seymour
Brand
Pass and Seymour
Model
880
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents