Legrand 880 Operating instructions

Brand: Legrand

Model: 880

Type: Operating instructions

This manual is also suitable for

880 Series Single-Service Floor Box Brass Covers - 895SP, 895TSP

Walkerbox

Brass Floor Box Covers

Cat. Nos. 895SP and 895TSP

INSTALLATION INSTRUCTIONS

Walker

electrical systems conform to

and should be properly grounded in com-

pliance with requirements of the current

National Electrical Code or codes admin-

istered by local authorities.

All electrical products may present a

possible shock or fire hazard if improperly

installed or used. Walker electrical prod-

ucts may bear the mark as UL Listed

and/or Classified and should be installed

in conformance with current local and/or

the National Electrical Code.

1. Locate the outlet box and

remove the top protector cap.

2. Pull necessary wires, following

the National Electrical Code

and/or local codes.

3. If using a box with adjusting

screws, adjust the floor plate

to the proper height.

4. Apply a bead of acrylic latex

around the box, sealing the

opening between the box

and the adjacent concrete.

5. Install a listed duplex wiring

device (not supplied by Walker),

the fill-in plate, and gasket.

6. Attach the floor cover (895SP or

895TSP) using the brass screws

provided. Fasten securely.

7. Install the screw plugs when

receptacle is not in use.

Carpet or Tile Trim to Fit

Inner Edge of Floor Plate Ring

1 1/2" [38mm]

Screw Plug

Walker Systems, Inc.

1000 Innovation Drive, Williamstown, WV 26187

IA0149 0800

Legrand 880 Operating instructions

Brand: Legrand

Model: 880

Type: Operating instructions

This manual is also suitable for

880 Series Single-Service Floor Box Brass Covers - 895SP, 895TSP

Download PDF

report

Legrand 880 Operating instructions

This manual is also suitable for

Legrand 880 Operating instructions

Related papers

Other documents