2. VISUAL COMFORT
  3. CHA8646

VISUAL COMFORT CHA8646 Operating instructions

  • I've reviewed the Assembly Instructions for the Table Lamp CHA8646. This document provides detailed steps on assembling the lamp, including installing the harp, shade, and bulb. It also covers safety precautions and care instructions. I'm ready to assist you with any questions you may have about this document or the assembly process.
  • What tools are required for assembly?
    Should I inspect the item before installing it?
    What should I use to clean the lamp?
Contemporary Balustrade Table Lamp
Item # CHA8646
ASSEMBLY INSTRUCTIONS
ALB Version
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction
and operation of it, as well as the hazards involved. Inspect item and
contents carefully. If any damage or defect is found, do not install.
Retain all packaging material until installation is complete and approved.
NOTICE:
A
C
D
E
Bulb not included
BTOOLS REQUIRED (NOT INCLUDED):
Scissors
1. Carefully remove all parts from the box. Place on a clean, soft surface.
2. Install harp (C) by squeezing together and inserting into the top of
saddle (D).
3. Remove finial (A) from harp (C).
4. Remove shade (B) from packaging and install to harp (C) using
finial (A).
NOTE: If shade has additional packaging, carefully cut off from
interior of shade to avoid damages.
5. Install light bulb into the socket.
6. Remove protective cover (E) from plug.
7. Plug into electrical outlet and test the fixture.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do
not use abrasive or chemical agents.
US
M
L
I
D
S
E
T
Contemporary Balustrade Table Lamp
Item # CHA8646
ASSEMBLY INSTRUCTIONS
CG Version
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction
and operation of it, as well as the hazards involved. Inspect item and
contents carefully. If any damage or defect is found, do not install.
Retain all packaging material until installation is complete and approved.
NOTICE:
A
C
D
Bulb not included
BTOOLS REQUIRED (NOT INCLUDED):
Scissors
1. Carefully remove all parts from the box. Place on a clean, soft surface.
2. Install harp (C) by squeezing together and inserting into the top of
saddle (D).
3. Remove finial (A) from harp (C).
4. Remove shade (B) from packaging and install to harp (C) using
finial (A).
NOTE: If shade has additional packaging, carefully cut off from
interior of shade to avoid damages.
5. Install light bulb into the socket.
6. Remove protective cover (E) from plug.
7. Plug into electrical outlet and test the fixture.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do
not use abrasive or chemical agents.
US
M
L
I
D
S
E
T
E
/