2. Crutchfield
  3. 701730

Crutchfield 701730 Owner's manual

  • Hello! I've reviewed the provided instructions for the Crutchfield Wiring Adaptor 120 70-1730. This document details how to correctly connect the adaptor to a new receiver by matching wires by function, not color and provides specific instructions for the illumination wire and unused wires. I'm ready to answer your questions about this product and its installation process.
  • How should I match wires of the adaptor to the receiver?
    What if my receiver does not have an illumination wire?
    What should I do with unused wires?
Receiver Wiring Adaptor
120 70-1730
Revision 02/05/18
STEP 1 -- MATCH & CONNECT WIRES
*120701730*
IMPORTANT
Before starting, compare items on your invoice with items
received. Thoroughly check packing materials. If an item
is missing, please call Crutchfield at 1-888-955-6000.
Copyright 2018 Crutchfield Corporation
Blue/White - Amplifier Remote
Red - 12 Volts Switched Power
Black - Chassis Ground
Yellow - 12 Volts Constant Power
Orange - Illumination
White - Left Front Channel
Gray - Right Front Channel
Green - Left Rear Channel
Violet - Right Rear Channel
Subwoofer
Connect to subwoofer output of aftermarket receiver.
The Subwoofer harness is not required on the CR-Z or the 2009-'11 Civic.
A.
B.
C.
D.
Match wires below to the matching function of each wire on your receiver (refer to instructions supplied with receiver). The wire colors of your
new receiver may, or may not, match the wire colors of the adaptor. Match adaptor and receiver wires by function, disregarding color.
Your receiver illumination wire could be Orange or Orange/White. As with other wires, match this wire to the illumination wire in this harness
by function, not by color. If your receiver does not have an illumination wire, tape off the illumination wire.
Individually tape off any unused wires.
Make final wiring connections following instructions on the next page.
Receiver Wiring Adaptor Connections
120 70-1730
Page 2
STEP 2 -- CONTINUED
A. Strip wires back 1/2”.
B. Twist wires together and
insert in crimp cap.
C. Squeeze middle of cap
for tight connection.
Copyright 2018 Crutchfield Corporation
STEP 3 -- APPLICATION
When ready to install the receiver, plug
the Wiring Adaptor from the new receiver
or receiver assembly into the factory
radio harness(es) in the vehicle dash.
D. Complete crimp connections
for all necessary wires.
E. Be sure to wrap any wires from
the Wiring Adaptor that are
not necessary (wires with no
match from the new receiver)
with electrical tape.
STEP 2 -- CRIMP CONNECTIONS
Tools & Parts
Required
Wire Stripper/Crimp Tool Crimp Caps
Unused Wire (tape over bare wires)
Receiver Wiring Adaptor
Generic Illustration
Generic Illustration
/