PALOVUE EarSound True Wireless Earbuds offer an immersive audio experience with superior sound quality, thanks to SBC and AAC audio decoding. Enjoy crystal clear calls with the built-in microphone and seamless connectivity via Bluetooth 5.0, ensuring a stable connection within a 10-meter range. Activate your preferred voice assistant with just three taps on either earbud, and effortlessly control music and calls with intuitive touch controls. Experience up to 32 hours of total playtime with the included charging case, and quickly power up with 15 minutes of fast charging for 1.
PALOVUE EarSound True Wireless Earbuds offer an immersive audio experience with superior sound quality, thanks to SBC and AAC audio decoding. Enjoy crystal clear calls with the built-in microphone and seamless connectivity via Bluetooth 5.0, ensuring a stable connection within a 10-meter range. Activate your preferred voice assistant with just three taps on either earbud, and effortlessly control music and calls with intuitive touch controls. Experience up to 32 hours of total playtime with the included charging case, and quickly power up with 15 minutes of fast charging for 1.
FCC WARNING
8
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Note:If shielded cables or special accessories are required for compliance,a
statement must be included which instructs the user to employ them,for
example,shielded cables must be used with this to ensure compliance with the
Class B FCC limits.
9
This device complies with Part 15 of the FCC Rules.Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference,and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
BrandPALOVUE
Model PALOVUE EarSound
NameWireless Earbuds
FCC ID: 2ARYG-EARSOUND
FONERIC UNITED TECHNOLOGIES Co.,Ltd
MADE IN CHINA
EarSound
USER GUIDE
4
PAIRING GUIDELINES
When using it for the first time, it needs to be paired and connected with the
mobile phone. After using the earphone, open the charging case and take out
the earphone, which will automatically connect with the connected mobile
phone;
Method: Take out two earphones, put the two earphones back into the charging
case, put the cover on the box, open the charging case again and take out the
two earphones→ refresh the mobile phone device Bluetooth→ search for the
"PALOVUE EarSound" Bluetooth device in the Bluetooth list, click pairing.
Pairing with another device: Turn off the Bluetooth of the original device A, the
headset will automatically disconnect and enter the pairing mode→ refresh the
Bluetooth device list of another device B→ search for the "PALOVUE EarSound"
Bluetooth device in the Bluetooth list, and click pairing.
3
Charging case in a low battery indication: After the earphone is put into the
charging box, the red light on the charging box flashes slowly for 4s and then
goes out
• Note: The charging case will stop charging the earphone when it is low, the
earphone in the charging case will automatically connect back to the last paired
device at this time, please charge in time when the charging case has a low
battery indication to avoid this phenomenon.
5
SPECIFICATION
Earphone size: 24.82*17.79*19.9mm Charging case battery capacity: 380 mAh
Earphone weight with charging case: 36g Charging case size: 71.98*Ø33.39mm
Earphone weight (single): 4g Charging case weight: 28g
Earphone battery capacity (single):
43 mAh
Charging case charging time (wired):
2 hours
Speaker impedance: 16Ω Audio decoding: SBC, AAC
Playing time single ear full charge: 6
hours With charging case full charge: 32 hours
Earphone charging time: 1.5 hours Quick charge: 15 minutes= 1 hour 30
minutes playback time
Communication distance: 10 meters
(in an open environment) Bluetooth protocol: HFP / A2DP / AVRCP
Rated input: 5V 500mA Operating temperature: 0 ~ 45
Frequency response range: 20Hz~20KHz
6
Put both TWS earphones into the charging case and open the cover, press and
hold the touch button of the earphone for 10 seconds, the red light on the left
and right earphones will flash fast for 5 seconds, and the red light will stop
flashing, then the reset will be completed. At this point, take out the two TWS
earphones, the red and green lights of the main earphones will flash alternately
slowly and the earphones will enter pairing mode.
*The above parameters are from laboratory test data. Playtime is tested under
experimental conditions in AAC format and 50% volume. Playing time, and
standby time may vary depending on settings, environment, usage, etc.
WARNING TIPS
RESET
7
If you have any questions, please contact the PALOVUE support team and we will
get back to you within 24 hours.
Email: [email protected]
Official website: www.palovue.com
SUPPORT
2
POWER ON GUIDELINES
Method 1: Open the cover of the charging case, take out the earphones and turn
it on automatically.
Method 2: Press and hold the left or right earphone touch button for 3 seconds.
CHARGING GUIDELINES
Earphone charging: Put the earphone into the charging case, the red light on the
earphone is always on to indicate that the earphone is successfully connected to
the charging case, and the charging case will automatically charge the earphone
Charging with the charging case: Close the charging case and connect the
type-C charging cable to the charging port.
--Blue indicator light of the charging case flashes slowly = Charging
--Blue indicator light of the charging case is always on = Charged Fully
SHUTDOWN GUIDELINES
Method 1: Put the earphones back into the charging case and shut down
automatically.
Method 2: The earphones automatically shuts down when the battery runs out.
Method 3: Disconnect, and will shut down after 5 minutes automatically.
1
EarSound
Earbuds Charging Case
Light Pogo Pins
Play music Call Other functions
Play & Call Touch Control
* When using only the left/right earphone, one tap is volume"+". If you want to
volume"-" you can via device to control.
One tap on the left earphone Volume “-“
One tap on the right earphone Volume “+“
Double-tap on the left/right earphone Play/Pause Answer/
Hang up
Long press the left earphone for 1.5 seconds Last song Reject
Long press the right earphon for 1.5 seconds Next song Reject
Triple-tap on the left/right earphone Voice assistant turn
on/ off
Long press the left/right earphone for 3 seconds Power on
DETAILED GUIDELINES
FCC WARNING
17 18
EarSound
12
ペアリングガイド
14
仕様
Ø
15
リセット
注意事項
16
サポート
11
パワーオンガイド
充電ガイド
パワーオフガイド
10
EarSound
13
詳細ガイド
LightsMic
Touch Area
1. There is no sound from one side of the two earphones, please put both TWS
earphones into the charging case and open the cover, press and hold the touch
button of the earphone for 10 seconds, the red light on the left and right
earphones will flash fast for 5 seconds, and the red light will stop flashing, then
the reset will be completed. At this point, take out the two TWS earphones, the
red and green lights of the main earphones will flash alternately slowly and the
earphones will enter pairing mode.
2. Please regularly clean the pogo pins of the earphone and the charging port with a
dry paper towel to avoid poor contact due to dirt.
3. If the other party finds that your voice is too low during the call, please try to
adjust the wearing position of the earphone.
4. After receiving the product, please put the earphones back into the charging case
for charging, which can ensure the effective use of the product.
--The connection is successful or the reconnection is successful, and the earphone
prompts: "Connected".
• Note: it is not supported to connect two devices at the same time. The next time
you turn on the device, it will be connected to the last paired device by default.
-
1
PALOVUE EarSound True Wireless Earbuds offer an immersive audio experience with superior sound quality, thanks to SBC and AAC audio decoding. Enjoy crystal clear calls with the built-in microphone and seamless connectivity via Bluetooth 5.0, ensuring a stable connection within a 10-meter range. Activate your preferred voice assistant with just three taps on either earbud, and effortlessly control music and calls with intuitive touch controls. Experience up to 32 hours of total playtime with the included charging case, and quickly power up with 15 minutes of fast charging for 1.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
in other languages
Other documents
-
Shenzhen Glory Star Technology Industrial TWS105 User manual
-
JayBird F5 User manual
-
imoshion TWS-i2 User manual
-
-
Headsets Y01 User manual
-
JOOM TWS T10 User manual
-
CANNICE A896-01 User guide
-
OpenRock B0CHF786XN User manual
-
Bazooka BPB24-G2 User guide
-
Jupiter JX05 User manual
