Mounting
Bracket
48 LEDs
Solar Panel
ON/OFF switch
Battery Compartment
SOLAR LED FLAME LANTERN 155034
Read these instructions carefully before first use. For outdoor use.
PRODUCT DESCRIPTION
FEATURES & SPECIFICATIONS
• Light Source: 48 x SMD2620 LEDs
• Output power: 20 lumens
• Power supply: 1x 1.2V 2000mAh Ni-Mh rechargeable battery (included)
• Solar Panel type: 2V Crystalline Silicon
• Flickering flame light effect
• Mounting bracket and hardware included
• Function Switch: ON/OFF
• Charging Time: 8 hours
• Using time: 5 - 6 hours
7”
11.8”
7.5”
5.9”
BATTERY INSTALLATION
• Unscrew the battery compartment cover located on the bottom of the unit.
• Replace with a new 1.2V 2000mAh Ni-Mh rechargeable battery.
• Screw the battery compartment cover back in place.
INSTALLATION
(A) Slide the ON/OFF switch to ON position before mounting.
(B) Unit can be mounted on any wall or smooth surface with mounting bracket and hardware (included).
Also can be placed by itself on any table.
NOTE:
1. Before the first time use, charge the solar product by placing it under direct sunlight for 8-10 hours
before using.
2. When the solar product is not in use for a long time, please remove the battery and store in a cool
and dry place to avoid the leakage.
3. If the battery is exhausted, the light will be dim or stop working. Durations of light depends on sunshine
exposure to the product, geographical locations, weather conditions and the hours of daylight.
MADE IN CHINA
/
