OFF ON
OFF ON
Lantern setup instructions
Step 1:
Attach the wire hanging handle by inserting the
curved ends of the handle into the raised tabs
located on the top of the plastic solar housing
compartment.
Step 2:
On the bottom side of the plastic solar housing
compartment, slide the power switch from the
“Off” position over to the “On” position. This
activates the AAA rechargeable battery that is
inside of the solar housing compartment.
Step 3:
Insert the circular end of the metal wire frame
support around the Dual LED bulb. Pull the lan-
tern up to begin to form a globe shape.
Step 4:
Attach the “notched” ends of the wire frame
support into the wire rings located on the
bottom of the lantern.
Step 5:
Hang your lantern where it will receive direct
sunlight. Solar products will produce
optimum results when fully charged in direct
sunlight for between 6-8 hours each day.
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
SunRay 342016 Operating instructions
-
SunRay 342017 User guide
-
Harbor Freight Tools 94740 User manual
-
-
Hampton Bay 46240-300PS User manual
-
Nature Power 23107 Owner's manual
-
SunRay 342075 User guide
-
One Stop Gardens Item 56783 Owner's manual
-
Hampton Bay QA5M-R5-ORB-C4 Operating instructions
-
Coleman 2600 Series User manual
