Fujitsu DISPLAY L22T-4 LED User manual
- Category
- Network antennas
- Type
- User manual
This manual is also suitable for
FCC Class B Compliance Statement
The following statement applies to the products covered in this manual, unless otherwise specified
herein. The statement for other products will appear in the accompanying documentation.
NOTE:
This equipment has been tested and found to comply with the limits for a "Class B" digital device,
pursuant to Part 15 of the FCC rules and meets all requirements of the Canadian Interference-
Causing Equipment Standard ICES-003 for digital apparatus. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in strict
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Fujitsu America, Inc. is not responsible for any radio or television interference caused by unauthorized
modifications of this equipment or the substitution or attachment of connecting cables and equipment
other than those specified by Fujitsu America, Inc. The correction of interferences caused by such
unauthorized modification, substitution or attachment will be the responsibility of the user.
The use of shielded I/O cables is required when connecting this equipment to any and all optional
peripheral or host devices. Failure to do so may violate FCC and ICES rules.
Declaration of Conformity
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Product type: LCD Display
Product name: L22T-3 LED
Model(s): L22T-3
Name of responsible party: Fujitsu America Inc.
1250E. Arques Avenue
Sunnyvale, CA 94085
U.S.A.
Phone No.: (408) 746-6000
We, Fujitsu America Inc., hereby declare that the equipment bearing the trade name and model
number specified above was tested confirming to the applicable FCC Rules under the most accurate
measurement standards possible, and that all the necessary steps have been taken and are in force
to assure that production units of the same equipment will continue to comply with the Commissions
requirements.
-
1
Fujitsu DISPLAY L22T-4 LED User manual
- Category
- Network antennas
- Type
- User manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Fujitsu S26361-K1481-V160 Datasheet
-
-
Fujitsu Stylistic V535 Operating instructions
-
-
Fujitsu Stylistic Q555 User manual
-
Fujitsu Stylistic Q616 User manual
-
-
-
Fujitsu LifeBook P727 Operating instructions
-