Security Labs SLC-1056 User manual
- Category
- Security camera accessories
- Type
- User manual
SLC-1056 Bullet Camera Installation:
Select a mounting location where the camera can be mounted securely. If an outdoor location is
selected, make sure that the camera is mounted under an eave or awning and has a clear view of the
area to be monitored. After confirming that the mounting location is free from electrical wires or other
hazards, mount the camera securely using the hardware supplied. Connect the video/power cable to the
camera as shown in the connection diagram.
Route the 50’ video/power cable from the camera (supplied) to the recording device (DVR), monitor, or
TV. Connect the BNC yellow video plug to the video in jack on the monitoring or recording device.
Connect the 2.1mm red power plug to the power adapter included with the camera. Observe that one
end of the 50’ video power cable has a power connection for the camera; the other end connects to the
power supply (different connectors). Refer to the connection diagram on the back of this page for cable
connections to your system.
SAFETY
The power adapter supplied with your camera is intended for indoor installation only. Use only the power
supply provided for camera power. To avoid possible shock hazards or product damage, do not alter the
connections or wiring. Use caution when connecting the adapter to AC voltage. Avoid exposure to
electrical wires or other hazards when routing AV or power cables through walls, ceilings, etc. Securely
mount the product to avoid possible damage or physical injury. Use the camera in a well ventilated area.
Do NOT allow camera to become submerged in any liquid.
SURVEILLANCE
Certain laws prohibit the recording or monitoring of individuals without their consent. The user of this
product assumes full responsibility for any and all violations of an individual’s rights regarding privacy
laws. Check with your local, and state authorities regarding video and audio surveillance.
User’s Manual
15540 Herriman Blvd. • Noblesville, IN 46060 • Customer Support 1-800-774-0284 • www.security-labs.com
High Resolution Color Weatherproof Bullet Camera
SLC-1056
Imager Type
Resolution
IR
Light Sensitivity
Video Format
Shutter
White Balance
Gain Control
Lens
Mount
Power
Operating Temp
Size
1/3” CMOS w/ IR cut filter
600 Lines
(30) IR LEDs with Halo Diffuser
.003 LUX
NTSC Comp 1V p-p
Auto Electronic
Auto
Auto
3.6mm
Swivel
12VDC; 250mA
14
0
-122
0
F
2.75”H x 3.75”D
Specifications
POWER
LAN-ETHERNET
AUDIO
OUT
AUDIO
IN
Recorder back panel
Camera-Recorder-Monitor Systems
Camera video
(yellow plug)
Power
(red plug)
MONITOR
VIDEO
IN
MONITOR
AUDIO
IN
50’ video/power cable
Power
supply
Red
power
plug
Yellow video
plug to open
video input
VIDEO
IN
CH 2
VIDEO
IN
CH 3
VIDEO
IN
CH 4
Camera
Monitor or TV
Questions? Call Toll Free Customer Support at 800-774-0284
MONITOR
VIDEO
OUT
VIDEO
IN
CH 1
Connection Diagram
-
1
-
2
Security Labs SLC-1056 User manual
- Category
- Security camera accessories
- Type
- User manual
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Security Labs SLC-159 User manual
-
Security Labs SLC-155 Datasheet
-
Security Labs SLC-3130 User guide
-
Security Labs SLC-1049C User manual
-
Security Labs SLC-1055 Datasheet
-
Security Labs SLM447 User guide
-
Security Labs SLM446 Quick start guide
-
Security Labs SLM462 User manual
-
Security Labs SLM445 User manual
-
Security Labs SLM463 User guide
