2. Noble House
  3. 70890

Noble House 70890 Installation guide

  • Hello! I've reviewed the assembly instructions for the Dining Chair. This document provides detailed steps, including a parts list and diagrams, to help you put the chair together. The instructions also cover testing the assembled chair for stability and proper alignment. I’m ready to answer any questions you have about the assembly process or the chair itself.
  • How many legs are included?
    What is used for tightening the bolts during assembly?
    What should I do after assembling the chair?
Label Picture Description QTY
A Back 1
B Seat 1
C Leg 2
Caution : Please read this carefully before you proceed
DINING CHAIR
Noble House Home Furnishings LLC Page 1 OF 6
Label Picture Description QTY
① Bolt (M8*50MM) 8
②Washer 8
③Spring Washer 8
④Allen Key 1
Before
Beginning
Assembly:
Overview
Seat (B)
Back (A)
Leg(C)
FRONT FACING
x 2
Noble House Home Furnishings LLC Page 2 OF 6
Step 1
Step 2
This Chair has multiple parts and may require up to 15 minutes to
assemble. To give you an overview of the Dining Chair parts, the above
picture is provided to help you put the various parts into perspective. Please
read through the instructions below to familiarise yourself with the parts and
steps before assembly.
Place the Back(A) and the Seat(B) on a clean, non-marring surface. Then
carefully peel away the Dust Cover from the edge of the Seat(B) and take
out the Legs(C).
Back （A）
Seat (B)
Back
Seat
Leg(C)
x 2
①
③
Noble House Home Furnishings LLC Page 3 OF 6
Put the Back(A) on a clean, non-marring surface and place the Seat(B)
on it.
Align the mounting positions of the Back(A) with the Seat(B) and attach
them using Bolts(①),Spring Washers (③),Washers(②) and the Allen
Key(④).
Do not fully tighten the Bolts at this time.
Step 3
Position the Legs(C) onto the assembled Back(A) and Seat(B) as shown in
the picture.
attach them using Bolts(①),Spring Washers(③),Washers(②) and the Allen
Key(④).
Do not fully tighten the Bolts at this time.
Seat (B)
Leg(C)
Back(A)
①
③
Noble House Home Furnishings LLC Page 4 OF 6
Step 4
Step 5
Your Chair is ready for use.
This Chair can only be used on a flat, level surface.
Stand the Chair up, and place on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected.
Gently and carefully, sit on the Chair.
This will help align all the parts at all the joints.
Tighten all Bolts fully in a sequential manner.
Then smooth down the Dust Cover on the Seat bottom with your hands on
all four edges.
1 if wobble
2 30-50cm
3 Test again
Test for
Back (A)
Seat (B)
Leg(
Noble House Home Furnishings LLC Page 5 OF 6
Noble House Home Furnishings LLC Page 6 OF 6
/