It's Exciting Lighting IEL-9002 Installation guide

Brand
It's Exciting Lighting
Model
IEL-9002
Type
Installation guide
Battery Powered
Horizontal Wall Sconce
Contents
On/Off Button
Mounting Posts
Back of Shade
Front of Back Plate Back of Back Plate
Hanging Groove
Battery Cover
Mounting Holes
• A - LED Back Plate x 1
Requires
• D Batteries x 3
(Not Included)
• B - Glass Shade* x 1
• C - Remote Control x 1
Telephone: + 1 813 343 5775
Email: [email protected]
Web: www.itsexcitinglighting.com
It’s Exciting Lighting is a Smart Living Home & Garden brand © 2016.2
Smart Living Home & Garden
A
B
C
INSTALLATION
1. Remove rear battery cover and place 3 x D cell batteries (sold separately) with the polarity as shown
in the battery compartment. We recommend alkaline or rechargeable batteries. Replace Cover.
IMPORTANT: pay careful attention to the polarity of the batteries and ensure they are inserted in the correct
direction as shown on the battery cover illustration. Failure to install batteries in the correct direction may cause
damage to the product.
2. Determine where the product is to be mounted and insert nail or screw (not provided) into the wall.
Mount back plate on wall by sliding hanging groove over inserted nail or screw.
3. Slide glass shade mounting holes onto LED Back Plate mounting posts to hold in place.
USE
1. Push button located on the bottom of the back plate unit to power on. Push the button a second
time to power off.
2. This unit includes a remote control which can be used to turn the unit on/off or adjust the brightness
(25%, 50%, 75%, 100%) when the unit On/Off switch on the unit is turn ON. If the unit On/Off switch
on the LED Back Plate is set to OFF, the remote control will not work.The remote control is powered by
1 x CR2025 Button Cell Battery (included).
INSTALLING AND REPLACING BATTERIES:
1. Slide shade off of LED Back Plate over mounting posts and set aside.
2. Remove back plate from wall.
3. Remove rear battery cover, remove old batteries and replace with new batteries. Replace battery cover. Dispose of
used batteries as instructed.
4. Replace back plate on wall and slide shade onto mounting posts to hold into place.
* Shape/Style of Shade may vary
Glass Sconce with
LED Horizontal Back Plate
SAFETY:
1. This light is intended for indoor use only. Keep away from moisture and direct sunlight.
2. Do not disassemble the unit.
3. Do not mix batteries. To prevent equipment damage, and possible injury, never mix batteries with different chemistries or
voltages in the equipment at the same time.
4. Consumed batteries need to be disposed of properly. Follow the instructions on the battery package. Battery selling
retailers provide special containers for environmentally friendly disposal.
5. Remove batteries from unit for long term storage to prevent damage from battery leakage.
WARNING: Pay careful attention to the polarity of the batteries being inserted. NEVER insert batteries
with the " + " of one battery facing the " + " of the other. Inserting the batteries incorrectly may cause
spark, fire or explosion.
Telephone: + 1 813 343 5775
Email: [email protected]
Web: www.itsexcitinglighting.com
It’s Exciting Lighting is a Smart Living Home & Garden brand © 2016.2
Smart Living Home & Garden
  • Page 1 1
  • Page 2 2

It's Exciting Lighting IEL-9002 Installation guide

Brand
It's Exciting Lighting
Model
IEL-9002
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents