PAC BKSUZK942 User manual

PAC
Brand
PAC
Model
BKSUZK942
Type
User manual

This manual is also suitable for

PAC BKSUZK942 is a vehicle-specific mounting kit that allows you to install an aftermarket stereo into your car. It is compatible with a variety of Chevrolet, Daewoo, and Suzuki models. The kit includes ISO mount brackets, screws, and detailed instructions to help you with the installation process. With this kit, you can easily upgrade your car's audio system and enjoy a better listening experience while on the road.

PAC BKSUZK942 is a vehicle-specific mounting kit that allows you to install an aftermarket stereo into your car. It is compatible with a variety of Chevrolet, Daewoo, and Suzuki models. The kit includes ISO mount brackets, screws, and detailed instructions to help you with the installation process. With this kit, you can easily upgrade your car's audio system and enjoy a better listening experience while on the road.

For information about other American International automotive
accessories visit our website at:
http://www.aius.net
CUSTOMER HELP LINE
USA 800-323-4329 • Canada 800-245-8777
©2015 AMERICAN INTERNATIONAL INDUSTRIES, INC.
SUZK942 Mounting Kit
Chevrolet
2004-08 AVEO
2004-08 AVEO 5
2004-06 AVEO WAGON
Daewoo
1999-02 LANOS
1999-02 LEGANZA
1999-02 NUBIRA
Suzuki
2004-06 VERONA
2004-08 FORENZA
2005-08 RENO
VEHICLE APPLICATIONS
iSUZK942
TECH Ver. 6/12 PRINT Ver. 4/15
2500 East Francis Street Ontario, CA 91761, U.S.A.
USA Sales (800) 336-6500
Canada Sales (888) 922-3006
1. Find your vehicle and remove necessary mounting tabs.
2. Attach ISO mount brackets to rear of kit as shown below.
3. Insert radio between ISO mount brackets and loosely attach to sides of radio using
screws provided with radio when possible or screws supplied with kit.
4. Slide radio forward or backward for desired look and tighten screws.
KIT ASSEMBLY INSTRUCTIONS NOTES:
1 6
1. Starting at the bottom, carefully pry outward and remove the Dash trims from each
side of the radio and climate controls.
2. Remove the (4) Phillips screws securing the factory radio to the sub-dash.
3. Carefully pull radio forward, disconnect the wire harness and antenna
lead from radio and remove radio.
DASH DISASSEMBLY INSTRUCTIONS
2004-08 CHEVROLET AVEO/AVEO 5/AVEO WAGON (Excluding LT models)
1. Carefully unsnap the trim from around the Radio/ Heater A/C controls & remove.
2. Remove the (2) Phillips screws securing the radio to the sub dash.
3. Remove the radio from the dash cavity, disconnect the wire harness & antenna lead
& remove the radio.
DASH DISASSEMBLY INSTRUCTIONS
1
999-02 DAEWOO NUBIRA
5 2
REMOVE ALL SHADED AREAS
ON BOTH LEFT AND
RIGHT BRACKETS
DO NOT REMOVE REAR
MOUNTING TAB
1. Carefully pry radio trim bezel outward to remove.
2. Remove the (4) screws securing the radio to the sub-dash.
3. Pull radio forward, disconnect the wire harness and antenna lead and remove radio.
DASH DISASSEMBLY INSTRUCTIONS
2
004-06 SUZUKI VERONA
REMOVE ALL SHADED
MOUNTING TABS ON BOTH
LEFT AND RIGHT BRACKETS
REMOVE ONLY LOWER HALF
OF MOUNTING TAB ON LEFT
& RIGHT BRACKETS
KIT ASSEMBLY INSTRUCTIONS
2004-06 SUZUKI VERONA
2004-08 CHEVROLET AVEO/AVEO 5/AVEO WAGON (Excluding LT models)
KIT ASSEMBLY INSTRUCTIONS
1999-02 DAEWOO NUBIRA
1. From below the glove box, remove the (2) phillips screws at the bottom
of the glove box.
2. Remove the (3) Phillips screws securing the top of the glove box housing frame and
remove glove box assembly.
3. Inside the glove box area on the left is a climate control cable that is attached with a
plastic clamp (Be sure you remember how you removed it so you will be able to
re-attach it when re-assembling the vehicle). Unfasten the cable clamp and unhook
the cable from the Heater control gear.
4. From under the driverʼs side dash, unfasten the single climate control cable
(same removal instructions as in step 3 above).
5. Starting from the bottom of the climate control/dash trim bezel, carefully pry outward
to release the (6) trim bezel clips and pull trim bezel forward.
6. Disconnect all harnesses from the rear of the climate controls and trim bezel and
remove bezel (Make sure you look to see how the (2) climate control cables were
routed for dash re-assembly).
7. Remove the (4) Phillips screws securing the radio or radio & pocket to the sub-dash.
8. Pull radio forward, disconnect the wire harness and antenna lead and remove radio.
REMOVE ALL SHADED
AREAS ON BOTH LEFT
AND RIGHT BRACKETS
1. Carefully unsnap the trim from around the radio & remove.
2. Remove the (2) Phillips screws securing the radio to the sub dash.
3. Remove the radio from the dash cavity, disconnect the wire harness &
antenna lead & remove the radio.
REMOVE ALL SHADED
MOUNTING TABS ON
BOTH LEFT AND
RIGHT BRACKETS
REMOVE ONLY UPPER HALF
OF MOUNTING TAB ON LEFT
& RIGHT BRACKETS
DASH DISASSEMBLY INSTRUCTIONS
2
004-08 SUZUKI FORENZA/2005-08 SUZUKI RENO
DASH DISASSEMBLY INSTRUCTIONS
1
999-02 DAEWOO LANOS & LEGANZA
3 4
KIT ASSEMBLY INSTRUCTIONS
2004-08 SUZUKI FORENZA/2005-08 SUZUKI RENO
KIT ASSEMBLY INSTRUCTIONS
1999-02 DAEWOO LANOS & LEGANZA
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

PAC BKSUZK942 User manual

PAC
Brand
PAC
Model
BKSUZK942
Type
User manual
This manual is also suitable for

PAC BKSUZK942 is a vehicle-specific mounting kit that allows you to install an aftermarket stereo into your car. It is compatible with a variety of Chevrolet, Daewoo, and Suzuki models. The kit includes ISO mount brackets, screws, and detailed instructions to help you with the installation process. With this kit, you can easily upgrade your car's audio system and enjoy a better listening experience while on the road.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents