Amayia Smoke Camera Guide Manual
1. Functional structure.
2. What to do before you start.
You need to have a Micro SD card, this item does not include a Micro
SD card.(Support up to 32GB Micro SD Card)
You need to charge the camera, and it takes about 3 hours if fully
charged.
After the above two steps are completed, you can start a simple
functional test.
3. Installation and testing steps.
Use Remote to control the camera to record what you want.
How to operate the remote control when the built-in battery works.
* Press the power key (enter standby status, the red light is stay on).
* Press the Video Recording key (the red light off to enter video recording
work, press it again to stop video recording and enter standby status).
* The function switch of the remote control must stop the previous working
status, enter the standby status(the camera red light is stay on), and press the remote
control again if you want (video recording, motion detection, taking pictures).
How to operate the remote control while the camera is charging.
* Press the Video Recording key (enter standby status, the red light is stay
on).
* Press the Video Recording key (the camera red light off to enter video
recording work, press it again to stop video recording and enter standby status).
* press the Motion Detection key (the camera red and blue light flash 4 time
off to enter motion detection mode and when a target is detected in front of the
camera, the camera's blue light flashes once and enters the video recording work,
press it again to stop motion detection and enter standby status).
* Press Take Photo key (the camera red light off, start taking pictures save to
Micro SD Card and Auto enter standby status).
* Press the power key to turn off the camera, but you cannot use the power
key to turn on the camera. At this time, you must disconnect the USB power cable
and reconnect the USB power cable to turn on the camera. Then press the Video
Recording key again to activate the camera(enter standby status, the red light is
stay on).
USB cable connected to your computer to set the date and time
Other Handling instructions:
1.Charging: in the connection of the computer and charger can charge, in
charging products , blue lights flashing condition. Off after finish charge.
2. Reset: When the product is stopped responding for the illegal operation or
other inexplicable reasons, switch to OFF or reconnect USB power cable, then hit ON
can product reset.
3.Please charge immediately when the battery low power and blue light began to
flash. When there is no electricity, the file is automatically stored. Insert the USB
cable connect to your PC, copy or cut the files in the card to the computer for play, or
use the card reader to read the file data, or remove the TF card.Recommended using
media player KM player and other players.
4.Features.
Pixel
2.0 mega pixel
Resolution
1600*1200P
Video format
AVI
Frame number
30fps
Vision angle
72°
Introduction photographing
10meters for straight-line distance
Minimum illumination
1LUX
Battery capacity
250MA
Continuous recording time
Over 12 hours
Remote operating distance
15m
Scope for sound recording
40
Power consumption
130MA/3.7V
Storage temperature
-2080
Working temperature
-10
60
Working humidity
15
85%RH
Type of memory card
Micro SD Card
Player software
Media player/KM player
USB Interface
USB 2.0
Operating system
WIN7/10/iMac/Linux
Time consumed of storage
1GB/40minutes
Charging time
About 3hours
5.FAQ:
Questions:
Answer:
Can not turn on
Remove the insulator Lock of power,
please Charge accordingly; Battery is not
contact Well, re-start
Can not charge the electricity
Replace the battery Or adapter
Blue light flashes rapidly
Re-start camera, low-power Charging
reminder, delete Redundant files from the
card, Put in TF card or replacing TF card
Remote controller is hard to
use
Align with the receivers head, remove
the insulator of remote controller, replace
battery or wait for reading the card
Can not connect with computer
Replace the data cable or computer
Sound is recorded with noise
or video is not clear and flaws.
Charging, replace Micro SD card
Other problems
Please contact seller: [email protected]
6.Warm Tips:
The power supply will produce a rising temperature at run time. This is a normal
phenomenon. If you do not need it to work for a long time, you can disconnect the
power supply.
Use Place: Please strictly abide by the relevant national laws and regulations,it
shall not be used for any illegal use, or at your own risk
For battery: the battery working hours will be shortened as time goes by. If you
do not use it for a long time, please be fully charged before use.
File security: This product is a non-professional storage device that does not
guarantee the integrity and security of internal storage files. Please immediately
back up your important files on your computer or other storage device
Recording quality: This product is non-professional recording equipment, does
not guarantee the effect of the recorded file to meet your expectations.
Working temperature: -5℃—40°C
Working humidity: 20%80%Do not place the product in a damp work
environment. The product does not have a waterproof function.
illumination: Please use it in a well-lit environment. Do not use the camera
directly against the sun and other light sources to avoid damage to the optical
device.
Clean: Do not use in dusty environment too long, so as not to contaminate the
lens and other parts of the dust, affecting the camera effect. The lens can be wiped
with a mirror paper or glasses cloth gently to keep clean.
other matters: the product is a precision electronic products, do not make it a
strong impact, vibration; do not use in a strong magnetic field, strong electric
field.
Supplementary information: Please do not hesitate to contact seller if you have
any other questions.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI