Page is loading ...
Questions about installation or product details? Contact our Tech Support team at 940-783-9914
Part# 31302: Works On: Ford 6.0L Super Duty ’03-’07
Plastic Clips
Custom A-Pillar Pod
Installation Instructions
A-Pillar Pod
POD
Adapter
WHAT’S INCLUDED:
STEP 1:
STEP 3:
STEP 4:
STEP 2:
Remove the two plastic caps on the grab handle on
the driver’s side.
Pull out the weather stripping around
the A-pillar (so it can be pulled down
easily). Release the two plastic clips
that hold the A-pillar in place. (Use
a at-head screwdriver.) Pull the
A-pillar down to access the screws
that secure the grab handle.
Using a Phillips screwdriver, remove
the two grab handle screws. Set
the grab handle and screws aside.
Push the stock A-pillar back into its
original location and secure it with
the plastic clips from step 3.
Remove the four bolts that were under the caps with
an 8 mm socket.
Cap Location
Questions about installation or product details? Contact our Tech Support team at 940-783-9914
Slide the custom pod onto the stock A-pillar so
that it sits just below where the handle would
t. Replace the grab handle by securing it
using the stock 8 mm bolts and replace side
panel and re-secure the weather stripping.
STEP 6:
GT Head Unit
GT Custom Pod Adapter
Custom Gauge Pod
(To OBDII Adapter Plug)
Main Harness
Main Harness Plug
If installing another tuner install the appropriate pod adapter at this time. LWTS+ requires part
# 30604 and GTX requires part # 30605, which is not included. Follow instructions on installing
the located on the inside of the packaging card. If you have stock speakers be sure to recon-
nect them at this time.
STEP 5:
31302-99_v1.1
/
