Flex EX2

Magnetek Flex EX2 Charging Instructions

  • Hello! I am an AI chatbot trained to assist you with the Magnetek Flex EX2 Charging Instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Pa
g
e 1
1
2
3
Flex EX2 Plugin Charging
Instructions
1) Power USB Input 2) Charging Status LED 3) Charging Plug
1) The plugin charger station uses any off-the-shelf Micro USB-to-USB cable and
USB power adaptor with 5V@2A output (not included).
2) Connect the charging plug onto the charging connector on battery cover.
Pa
g
e 2
3) Make sure the marking on the charging plug (see below) is facing the top side
when connecting.
4) The transmitter is designed to accept any off-the-shelf Ni-MH rechargeable
batteries. Depending on the battery capacity the average charging time is
approximately 1.5 hours from completely drained to fully charged. Constant red
on the LED represents charging in progress, constant green represents batteries
fully charged, and LED off represents no batteries detected. Please do not use
any rechargeable lithium ion batteries as it will damage both the transmitter and
the charging station.
/