5
Notes
Do not display a still picture ■
for a long time
This causes the image to remain on the
plasma screen (“image retention”).
This is not considered a malfunction and is
not covered by the warranty.
Typical still images
Channel number and ●
other logos
Image displayed in ●
4:3 mode
Video game●
Computer image●
To prevent image retention, contrast is
lowered automatically after a few minutes
if no signals are sent or no operations are
performed. (p. 89)
Auto power standby function ■
If no signal is received and no operation ●
is performed in Analogue TV mode for
30 minutes, the unit will automatically go
to standby mode.
The unit will automatically go to Standby ●
mode if there are no signal and no
operation between the Display Unit and
the Tuner Box for a while.
Tuner Box - after 1 minute
Display Unit - after 10 minutes
Keep the unit away from these ■
types of equipment
Electronic equipment ●
In particular, do not place video equipment
near the unit (electromagnetic interference
may distort images / sound).
Equipment with an infrared sensor ●
This unit also emits infrared rays (this may
affect operation of other equipment).
Adjust the panel to your desired ■
angle (TX-P46Z1E)
Ensure that the pedestal does not hang ●
over the edge of the base even if the TV
swivels to the full rotation range.
Do not place any objects or hands within ●
the full rotation range.
10˚ 10˚
(View from the top)
500 mm
383 mm
Set the mark at the centre as
illustrated, to ensure full degree
rotation in either direction.
When cleaning the unit, remove the mains plug
■
Cleaning an energized unit may cause electrical shock. ●
When the unit is not going to be used for a ■
long period of time, remove the mains plug
The unit will still consume some power even in the Off mode, ●
as long as the mains plug is still connected to a live socket
outlet.
Transport only in upright position ■
Transporting the Display Unit with its display panel facing ●
upright or downward may cause damage to the internal
circuitry.
Allow sufficient space around the Display ■
Unit for radiated heat
Minimum distance
10
10
10
3
(cm)
When using the pedestal, keep the space between the ●
bottom of the Display Unit and the surface where the Display
Unit is set.
In case of using Wall-hanging bracket, follow the manual of ●
it.
Do not block the rear air vents ■
Blocked ventilation by newspapers, table cloths, curtains, ●
etc. may cause overheating, fire or electrical shock.
Do not expose your ears to excessive ■
volume from the headphones
Irreversible damage can be caused. ●
The Display Unit is heavy. Handle the ■
Display Unit by 2 or more people. Support
as shown to avoid injury by the Display Unit
tipping or falling.
When the Wireless Receiver is attached, do not hold it.●
Caution
Radio waves
Do not place the unit in any medical institutions or locations ●
with medical equipment. Radio waves from the unit may
interfere with the medical equipment and cause accidents
due to the malfunction.
Do not use the unit near any automatic control equipment ●
such as automatic doors or fire alarms. Radio waves from
the unit may interfere with the automatic control equipment
and cause accidents due to the malfunction.
Keep the remote control, Tuner Box and Wireless Unit away ●
at least 22 cm from the location where a cardiac pacemaker
is implanted. Radio waves from the unit may interfere with
the operation of the pacemaker.
Do not disassemble remote control, Tuner Box or ●
Wireless Unit. It may cause troubles such as difficulties in
communication.
