JBA 1950S User manual

1950S
Brand
JBA
Model
1950S
Type
User manual
Installation Instructions & Warranty Information
1950S ~ 1996-02 Dodge Ram 8.0 V10
1951S ~ 2003-05 Dodge Ram 8.0 V10
Cat4Ward® Headers
REV. 6 5-10-22 DSL
1. From underneath the vehicle disconnect the Y-pipe from the exhaust manifold.
2. Remove the nuts attaching the heat shields to the factory manifolds and remove the
heat shields. Then unbolt and remove the manifolds.
3. Clean the sealing surface on the cylinder heads. Apply a bead of sensor safe high
temp RTV on the header dome.
4. Apply a small amount of Anti Seize to the supplied header bolts. Using the supplied
gaskets and fasteners install the new headers. Tighten bolts evenly from the center
out.
5. Reconnect the exhaust system to the headers using the supplied hardware. Torque
the fasteners to 35 ft./lbs.
6. Check to make sure there is adequate clearance on plug wires, battery cables, wire
looms, brake lines, etc.
7. Re-connect battery cables.
8. Start the engine and let it warm up. Check for leaks. Shut engine o and let it cool
down. Check to make sure all fasteners are tight.
9. All tubular headers require maintenance including periodically checking and
retightening of the header bolts.
Parts List:
(1) Driver’s Side Header Assembly (1) Passenger’s Side Header Assembly
(2) Header gaskets (16) Star Washers
(16) 8mm -1.25 x 25mm header bolts (1) CARB EO Sticker
(4) 3/8” x 2 1/2” Collector Bolts, Nuts & Washers
  • Page 1 1
  • Page 2 2
  • Page 3 3

JBA 1950S User manual

1950S
Brand
JBA
Model
1950S
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents