ABQ Industrial BDX Series Operating instructions

INSTRUCTIONS - Tether Attachment for the BDX Series Moisture

Meter

Each meter includes two short pieces of nylon cord to tie into tethers for

the pin and connector caps, if desired.

Step 1 – Remove the connector cap.

Distributed by: ABQ Industrial LP USA

Tel: +1 (281) 516-9292 / (888) 275-5772 eFax: +1 (866) 234-0451

Web: https://www.abqindustrial.net E-mail: [email protected]

Distributed by: ABQ Industrial LP USA

Tel: +1 (281) 516-9292 / (888) 275-5772 eFax: +1 (866) 234-0451

Web: https://www.abqindustrial.net E-mail: [email protected]

Step 2 – Thread one end of the Tether through the cavity of the meter.

Step 3 – Feed both ends through the top side of the connector cap.

Step 4 – Tie a single knot on the end of the Tether.

Step 5 – Slide the connector cap to the end so that the knot is inside and place

the cap back onto the meter as shown.

Step 6 – Remove the Pin Cover Cap and repeat the same steps.

Rev. 6-16-2021-1

Distributed by: ABQ Industrial LP USA

Tel: +1 (281) 516-9292 / (888) 275-5772 eFax: +1 (866) 234-0451

Web: https://www.abqindustrial.net E-mail: [email protected]

Distributed by: ABQ Industrial LP USA

Tel: +1 (281) 516-9292 / (888) 275-5772 eFax: +1 (866) 234-0451

Web: https://www.abqindustrial.net E-mail: [email protected]

Download PDF