2. ABQ Industrial
  3. BDX Series

ABQ Industrial BDX Series Operating instructions

  • Hello! I've reviewed the instructions for tether attachment for the ABQ Industrial BDX Series Navigator BDX-30 moisture meter. This document details how to attach the nylon cord tethers to the connector and pin caps, a process that involves a few steps. I'm ready to answer any questions you have about the instructions or the device.
  • What is included in the box for tethering?
    What is the first step to attach tether to connector cap?
    How many knots to tie on the end of the tether?
INSTRUCTIONS - Tether Attachment for the BDX Series Moisture
Meter
Each meter includes two short pieces of nylon cord to tie into tethers for
the pin and connector caps, if desired.
Step 1 – Remove the connector cap.
Distributed by: ABQ Industrial LP USA
Tel: +1 (281) 516-9292 / (888) 275-5772 eFax: +1 (866) 234-0451
Web: https://www.abqindustrial.net E-mail: [email protected]
Distributed by: ABQ Industrial LP USA
Tel: +1 (281) 516-9292 / (888) 275-5772 eFax: +1 (866) 234-0451
Web: https://www.abqindustrial.net E-mail: [email protected]
Step 2 – Thread one end of the Tether through the cavity of the meter.
Step 3 – Feed both ends through the top side of the connector cap.
Step 4 – Tie a single knot on the end of the Tether.
Step 5 – Slide the connector cap to the end so that the knot is inside and place
the cap back onto the meter as shown.
Step 6 – Remove the Pin Cover Cap and repeat the same steps.
Rev. 6-16-2021-1
Distributed by: ABQ Industrial LP USA
Tel: +1 (281) 516-9292 / (888) 275-5772 eFax: +1 (866) 234-0451
Web: https://www.abqindustrial.net E-mail: [email protected]
Distributed by: ABQ Industrial LP USA
Tel: +1 (281) 516-9292 / (888) 275-5772 eFax: +1 (866) 234-0451
Web: https://www.abqindustrial.net E-mail: [email protected]
/