WarmlyYours TempZone™ Cut & Turn Single Conductor Wire Repair Splice Kit Installation guide

Category
Cable assembly tools
Type
Installation guide

This manual is also suitable for

Damaged Area
Cut
Teflon Insulation
Inner Core
Braided Ground Sheath
1/2”
Cut
You will need:
1) A Splice Kit
2) Tools
crimp solder connector
1/4” heat shrink tubing
Fastenal P/N 0714595
adhesive metallic tape
wire crimper
hot air pistol
Step 1 - Determine where the damage is and make a
clean cut through the wire.
Step 2 - Place a heat shrink tube over one side of the wire.
S
tep 3 - Strip 1” of the outer insulation from both cables.
Step 4 - Separate the braided sheath wire from the
inner layer of insulation.
Step 5 - Shorten inner conductor wire to 1/2”.
Step 6 - Insert the inner conductor wires into each
side of the crimp on connector.
Step 7 - Compress the crimp on connector on each
side using Crimping tool.
Step 9 - Overlap both braided sheath wires and
connect them with a strip of metallic tape.
Step 10 - Slide the heat shrink tube over the connections and shrink
it with a hot air pistol. Do not use a naked flame.
a
a
a
a
a
b
b
b
b
b
Adhesive metallic tape
BRAIDED GROUND SHIELD
TEFLON INSULATION
TEFLON INSULATION
STRANDED CONDUCTOR CORE
Wire Construction
Instructions for TempZone Wire Repair
24/7 Installation Support • Lifetime Technical Assistance • Free Design Service • www.WarmlyYours.com • (800) 875-5285
10/2009 - 30084-A
Fastenal P/N 0710573
butane torch
IT IS EXTREMELY IMPORTANT THAT NO INNER CONDUCTOR
WIRES ARE EXPOSED OUTSIDE OF CONNECTOR!
Step 8 - Heat Crimp Connector to seal the heatshrink + melt
the solder pellet.
  • Page 1 1

WarmlyYours TempZone™ Cut & Turn Single Conductor Wire Repair Splice Kit Installation guide

Category
Cable assembly tools
Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI