WarmlyYours Circuit Check Installation guide

Category
Motorcycle Accessories
Type
Installation guide
Circuit Check Installation for
TempZone™ Cut & Turn Roll (Single conductor)
TempZone™ Standard Mat (Single conductor)
TempZone™ Custom Fit Mat (Single conductor)
10059-E
Rev 3/2013
1. LAY OUT THE WARMLYYOURS WARMING SYSTEM ROLL(S)
Lay out the roll(s) in accordance with the design layout and instructions provided
by WarmlyYours.
2. TEST THE CIRCUIT CHECK1
Before connecting any wires, install the batteries in the device and turn it “on” and “off” to test
the alarm.
After confirming that the alarm is in good working order, connect the wires as follows:
• Connect 1st inner conductor core wire to the Black terminal.
• Connect 2nd inner conductor core wire to the Red terminal.
• Connect both ground sheaths to the Green terminal.
Turn on the Circuit Check and touch the ground sheath to one of the inner conductor wires.
This should activate the alarm.
If the Circuit Check does not pass all these tests, please call WarmlyYours Customer Service at
(800) 875-5285.
3. ACTIVATE THE CIRCUIT CHECK AND PROCEED TO INSTALL FLOORING
4. IF THE CIRCUIT CHECK ALARM SOUNDS, STOP!
The alarm sounding indicates a short in the circuit or break in the system. Check the trouble
shooting guide in the WarmlyYours installation manual or call 24/7 Installation Support at
(800) 875-5285.
WarmlyYours will supply a splice kit to repair the short for the cost of S & H.
Alternatively, the wire may be repaired by an electrician.
Please turn over to view detailed illustrations for wiring
Tempzone to the Circuit Check
Note1: This device is NOT an Ohm meter. WarmlyYours requires that the roll be tested before, during and after
installation with a Digital Ohm meter.
Installation Support • No Nonsense™ Warranty •(800) 875-5285 • www.WarmlyYours.com
10059-E
Rev 3/2013
Installation Support • No Nonsense™ Warranty •(800) 875-5285 • www.WarmlyYours.com
Wiring Tempzone to Circuit Check
SHEATH
CORE
CORE
Ending Wire2
From Warming System
Beginning Wire1
From Warming System
ON OFF
BLACK
GREEN
(Sheath)
RED
1. “Beginning” wire is the lead wire from the start of the warming system roll.
2. “End” wire is the lead wire from the end of the warming system roll.
Notes:
BRAIDED GROUND SHEATH
COLD LEAD
RED 240V
OR
WHITE 120V
BRAIDED GROUND SHEATH
COLD LEAD
TAPE INDICATORS
RED 240V OR
YELLOW 120V
Wire Construction
TempZone Single Conductor MatsTempZone Standard and Custom Fit Mats
Circuit Check Installation
for TempZone Single, Standard
and Custom Fit Mats
Page 2
BLACK
RETURN
WIRE
OUTER INSULATION LAYER
INNER
INSULATION
LAYER
  • Page 1 1
  • Page 2 2

WarmlyYours Circuit Check Installation guide

Category
Motorcycle Accessories
Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI