![](//vs1.manuzoid.com/store/data-gzf/e174c72c0de5d745c52af156d7a0e8c1/2/002152916.htmlex.zip/bga.jpg)
water to remove the lint.
MAINTENANCE
AUTO MATIC WASHING MACHINE
function without water level display. If you need to select other water levels, press
the "Water Level" button to select.
After turning on the power, if there is water in the washing barrel, the washing
machine cannot enter the blur function. The default is the "Standard" program.
4) Press the “Start/Pause” button to boot the system.
After the system starts, if you need to change the setting program, you can press
the "Start/Pause" button to pause the system operation, then press other buttons
the newly set program.
5) Close the top cover and the washing machine enters the running state.
Do not open the top cover during the operation of the washing machine, especially
during the dehydration proc
7 How to operate the “Reuse” function. (“Reuse”: When this function is
selec
ted, the last drainage will not be executed. Water can be collected and
reused for other purposes.)
After turning on the power, the default setting of the machine is no “Reuse”
function, and the “Reuse” indicator light is off. If you want to use this
function, you can start the program by pressing the “Rinse” button, so that
“Reuse” light on. If you don’t need this function, press the "Rinse" button
again to turn off the “Reuse” light.
After selecting the “Reuse” function, the “Reuse” light will flash when the
program runsuntil the last drainage, and an alarm will be triggered every five
minutes to prompt the user to receive water. After the user is ready to receive
the water container, press the "Rinse" button, the “Reuse” light goes out, and
drainage begins. Pressing the "Rinse" button during this drainage process can
switch between drainage and stopping drainage.
If the user does not press the "Rinse" button during the last drainage, the
“Reuse” light will continue to flash and an alarm will sound every five minutes,
prompting the user tohandle the issue until the "Rinse" button is pressed before
proceeding to the next step.