3M Adper™ Single Bond Plus Adhesive Intro Kit, 51101 User guide

Type
User guide

This manual is also suitable for

PORCELAIN REPAIR
Adper
Single Bond Plus Adhesive
Filtek
Restoratives
3
1 of 2
1
2
Preparation:
• Isolate and clean the surface.
• Roughen the alloy surface with a bur, diamond or sandblast
technique.
• Remove all loose or weakened porcelain. Bevel the margin.
Remove surface glaze 1mm beyond margin.
Etchant:
• Apply Scotchbond
Etchant to
porcelain and alloy. Wait 15 seconds.
• Rinse.
• Dry 2-5 seconds.
Silane Prime:
• Apply RelyX
Ceramic Primer to the
porcelain and alloy surface.
• Dry.
Adhesive:
Apply 2 consecutive coats of Adper
Single Bond Plus Adhesive to silane
primed surfaces.
• Dry gently for 2-5 seconds.
• Light-cure for 10 seconds.
PORCELAIN REPAIR
Adper
Single Bond Plus Adhesive
Filtek
Restoratives
2 of 2
3M ESPE Customer Hotline 1-800-634-2249 70-2009-3631-1
Please refer to instructions for more detailed information 44-0007-4209-6
as well as precautionary and warranty information. Used under license in Canada. © 2004 3M
3M, ESPE, Adper, and Scotchbond are trademarks of 3M or 3M ESPE AG.
4
5
Mask Metal:
• Mask the metal surface with a thin
layer (.25 - .5mm) of the appropriate
3M
ESPE
Masking Agent shade,
using a brush.
• Light-cure each layer for 20 seconds.
Place Filtek
Restorative:
• Place Filtek
Restorative in increments.
• Light-cure each increment. (Reference
Light-Cure chart for thickness and cure
time.)
  • Page 1 1
  • Page 2 2

3M Adper™ Single Bond Plus Adhesive Intro Kit, 51101 User guide

Type
User guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI