Adcraft WB-100 User manual

Type
User manual

Adcraft WB-100 is a hot water dispenser with a maximum capacity of 20 liters. It takes around 60 minutes to boil a full capacity and can maintain a boiling temperature when the thermostat is set to 100°C (or 212°F). The dispenser has an indicator light that turns on when the water is ready to be served, and it automatically restarts and heats up when the temperature cools down by 10°C or 50°F. The device has a minimum volume requirement of 1/3 of the maximum capacity and should not be moved or carried when switched on or when containing water.

Adcraft WB-100 is a hot water dispenser with a maximum capacity of 20 liters. It takes around 60 minutes to boil a full capacity and can maintain a boiling temperature when the thermostat is set to 100°C (or 212°F). The dispenser has an indicator light that turns on when the water is ready to be served, and it automatically restarts and heats up when the temperature cools down by 10°C or 50°F. The device has a minimum volume requirement of 1/3 of the maximum capacity and should not be moved or carried when switched on or when containing water.

Hot Water Dispenser
Instruction Manual
WB-100
O P E R A T I N G I N S T R U C T I O N S
1. Switch is off and thermostat is set at “0” position.
2. Use cool water and fill to at least half of total capacity of the urn
3. Place lid on the machine.
4. Plug the power cord into electric outlet.
5. Turn the power switch “on”. The light on the switch will light up to indicate the power is
connected.
6. Turn the knob of controller to the temperature that you prefer.
7. The indicator light will be off until the water in the urn starts to heat up.
8. When indicator lights up, the boil process is completed. Hot water is now ready to be
served.
9. When the temperature cools down about 10°C or 50°F, the unit will restart and heat up
automatically. The indicator will light up again.
10.If you set the thermostat near 100°C(or 212°F) then the unit will maintain a Boiling
temperature until user reduces the setting.
C L E A N I N G I N S T R U C T I O N S
On areas of the heating element, hard water will cause chalk and limestone to accumulate
over time. We recommend you de‐sediment when you find there are scale sediments at the
bottom of the machine.
1. Pour 200ml of fresh lemon juice or concentrated lemon juice into the urn.
2. Wait for 5 minutes to allow the lemon juice to penetrate.
3. You may use a brush with soft bristles to brush the heating element lightly.
4. Repeat steps 1‐3 until the limestone is removed.
5. Use a dry cloth to remove the lemon juice away.
6. Rinse with clean water and brush the heating element lightly.
Clean every 4 weeks to ensure the unit will work normally.
Do not touch the outside of the appliance during use! IT IS HOT !!!
I M P O R T A N T S A F E G U A R D S
*Operator must read these instructions and technical data carefully.
*Never immerse the machine in water.
*The unit is for indoor use only. Unit should be placed on a sturdy surface.
*When the unit is in use, some parts will be very hot. Do not touch.
*Unplug the cord , when the machine is not being used.
*Do not disconnect the appliance with wet hands; and do not pull the power cord.
*The mi
n
*The lid
*Never
m
*Never
w
*All of t
h
C
Specific
B
n
imum vol
u
must be in
m
ove or ca
r
w
ash using
h
h
e importa
n
aution! Ho
t
ations:
Model
Vo
W
a
Max.
C
B
oil Time f
o
Temperat
u
u
me to ope
r
a closed po
ry the unit
w
igh‐press
u
n
t items are
t
Surface
Number
ltage
a
ttage
C
apacity
o
r full capa
c
u
re Controll
e
r
ate must b
e
sition whe
n
w
hen it is s
w
u
red jet wa
t
marked by
c
ity
e
r
e
at least 1
/
n
unit is ser
v
w
itched on
t
er.
for y
o
/
3 of the ma
v
ing.
and/or wh
o
ur attenti
o
WB‐
1
120 V, 5
0
135
0
20 li
t
Around
6
86‐2
1
ximum cap
a
en containi
n
o
n in the fol
l
1
00
0
‐60Hz
0W
t
er
6
0 Min.
1
2 F
a
city.
n
g water.
l
owing pag
e
e
s.
ACE Electrical Equipment One Year Warranty
ACE warrants its equipment against defects in materials and workmanship, subject to the
following conditions:
This warranty applies to the original owner only, and is not assignable.
ACE Electrical Equipment is warranted for one year, effective from the date of purchase by
the original owner. A copy of the original receipt, or other proof of purchase is required to
obtain warranty coverage.
Should any product fail to function in its intended manner under normal use within the limits
defined in this warranty, at ACE’s discretion, such product will be repaired, replaced with a
refurbished unit, or replaced with a new unit by ACE, after defective unit has been inspected
and defect has been confirmed. ACE does not assume any liability for extended delays in
replacing any item beyond its control. This warranty does not apply to rubber and non-
metallic synthetic parts where usage, wear, or lack of preventative maintenance may create
abnormal replacement rates, and these parts are excluded from this limited warranty.
This warranty covers products shipped into the 48 contiguous United States, Hawaii, and
metropolitan areas of Alaska and Canada. Warranty coverage on products used outside the 48
contiguous United States, Hawaii and metropolitan areas of Alaska and Canada may vary.
Contact ACE for details at 1-800-223-7750
The following conditions are not covered by warranty:
Equipment failure relating to improper installation, improper utility connection or supply and problems due
to improper ventilation.
Equipment that has not properly been maintained, damage for improper cleaning, and water damage to
controls.
Equipment that has not been used in an appropriate manner, or has been subject to misuse, neglect, abuse,
accident, alteration, negligence, damage during transit, delivery or installation, fire, flood, riot, or act of
God.
Equipment that has the model number or serial number removed or altered.
Equipment on which the security seal has been broken.
If the equipment has been changed, altered, modified, or repaired without express written
permission from ACE, then the manufacturer shall not be liable for any damages to any
person or to any property, which may result from the use of this equipment thereafter.
This equipment is intended for commercial use only. Warranty is void if equipment is used
in other than a commercial application.
In the event your repair is not covered under the stated warranty provisions, parts are
available by calling 1-800-223-7750. Equipment not covered by repair should be picked up
from our warehouse facility within 10 business days from notification date. Any and all
arrangements and expenses for the return of this merchandise is your responsibility.
“THE FOREGOING WARRANTY IS IN LIEU OF ANY AND ALL WARRANTIES
EXPRESSED OR IMPLIED INCLUDING ANY IMPLIED WARRANTY OF
MERCHANTABILTY OR FITNESS FOR PARTICULAR PURPOSES AND CONSTITUES THE
ENTIRE LIABILITY OF ACE. IN NO EVENT DOES THE LIMITED WARRANTY EXTEND
BEYOND THE TERMS STATED HEREIN.”
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Adcraft WB-100 User manual

Type
User manual

Adcraft WB-100 is a hot water dispenser with a maximum capacity of 20 liters. It takes around 60 minutes to boil a full capacity and can maintain a boiling temperature when the thermostat is set to 100°C (or 212°F). The dispenser has an indicator light that turns on when the water is ready to be served, and it automatically restarts and heats up when the temperature cools down by 10°C or 50°F. The device has a minimum volume requirement of 1/3 of the maximum capacity and should not be moved or carried when switched on or when containing water.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages