BH-005 Bluetooth Car Kit User’s Manual
I
BH-005 BLUETOOTH CAR KIT
Function :
1. Bluetooth v1.1 compliance
2. Output level, 0dBm, class 2
3. 10 meters working range
4. Voice dialing out function by push button on the car kit (subject to mobile phone support)
5. Noise suppression microphone with flexible tube wire to fit user’s requirement
6. Automatic reconnection if Bluetooth link is disrupted
7. Speaker volume is adjustable
8. Two colour LED for standby or talking indication.
9. Echo cancellation by high performance ASIC DSP.
10. Charging the BH005 unit, there 2 ways to charge the 3 AA recharable batteries either by the
car cigar lighter or by the mains travel charger
11. Suitable for all Bluetooth mobile phones, Nokia, Sony/Ericsson Seimens , Motorola,
Panasonic, Etc …
Installation
1. Open the battery door and insert 3 AA batteries.(notice the direction of the battery)
2. Slide the on/off button to the position “BAT “.
3. The “LED” will start to blink (green), and BH005 unit is ready for working.
4. Following the pairing procedures below to pair the BH005 unit with your mobile
phone.
5. Put in “ Clip” into the hole on the back of the BH005 unit
6. The BH005 unit can be now slide on to the sun visor
7. Adjust the “Volume Control” see note under hands free profile .
8. Adjust the “Boom Microphone” to the best position. For you to talk
9. Plug the “Power lead” into the cigar lighter socket of your car, and move the
“on/off switch” to the “CAR” position, this is now using the car battery .
Pairing procedure
Once the BH-005 unit has been paired with the mobile phone you can leave this function switched on in your
mobile phone, so when you return to your vehicle you can turn your BH005 unit on and the pairing procedure
will automatically be activated
Mobile PHONE WITH HEADSET PROFILE
1. Move the on/off switch of BH-005 to right position “CAR” or “BAT” according
to the applied power “car cigarette” or “ 3 AA Batteries” to it respectively.
2. Push and hold the “push button” of slide switch of BH-005 until you hear Hi-Low
tones coming out from the speaker, and the LED light will be turned off.
3. Push and hold the “ push button” of slide switch of BH-005 until you hear three
tones coming out from the speaker, and the LED turns on with green & red light.
4. Then you can start the pairing procedure with your cell phone.
Mobile PHONE WITH HANDSFREE PROFILE
1. Move the on/off switch of BH-005 to “CAR” or “BAT” according to the applied
power “cigar lighter lead” or “3 AA batteries” .
2. Push & hold the “on/off button of the BH-005 unit until you hear Hi-Low tones
from the speaker, and the LED light will go out
3. Push & hold the “on/off button” to turn the BH-005 unit on, until you hear three
tones coming out from the speaker, and the LED turns green & red light, and then
push on/off button once more and you will hear short beep from the speaker.
4. Now you can start the pairing procedure with your Mobile Phone.
Note :
1. Adjust the “volume of the BH005 unit to suit your hearing, but you may need
to adjust your mobile phone volume, so the caller does not hear there own
voice (feed back)
2. The pass code of BH-005 unit for pairing is 1234.
3. After completing pairing procedure, BH-005 unit is back to the stand-by mode
and ready to use with the paired mobile phone
5. Only 1mobile phone can be used with the BH005 unit at one time
VOICE DIALING FUNCTION
Making sure that your mobile phone supports voice dialing function. Please record your voice dialing
message into your mobile phone first. The voice dialing is simple - just press the on/off button of BH-005
unit, you will hear a beep tone now say the desired name the mobile will start dialing now
A. P800 (SONY – ERICSSON)
1. Press “control panel”
2. Press “connections”
3. Press “Bluetooth”
4. Press “Add “ to starting searching BH-005 device
5. Press BH-005
6. Enter “1,2,3 4” for pass code, and then press “Done”
7. Press “ “ , Allowed to connect without confirmation, then press “ Done”
8. Press “ Done” to finish pairing procedure and then you can use the Car kit with
your P800 mobile phone now.
B. 8910 (NOKIA)
1. Select “Menu”
2. Select “Bluetooth”
3. Select “Search for audio accessories” to starting searching BH-005
4. Select “BH-005”
5. Enter “1,2,3 4” for pass code, then press “OK”
6. Press “OK”
7. Select “View paired device”
8. Select “BH-005” , and select “Options”
9. Select “Request conn. Authorization”, and select “No”
10. Select “Back” and “Exit” to finish pairing procedure and then you can use the
BH-005 with your 8910 phone now.
Note: Please turn on the automatic answer function of Headset and hands-free of
you 8910 phone, then BH-005 can answer calls automatically, otherwise you
may have to push the “push button” on the BH-005 to answer the incoming calls.
C. 3650 (NOKIA)
1. Press “Menu”
2. Select “Connection” and press “Open”
3. Select “Bluetooth” and press “Open”
4. Shift to left for pairing device and select “new device” to start searching
5. Select “BH-005”
6. Enter “1,2,3 4” for pass code
7. Select “BH-005”, and select “connection”
8. Select “BH-005” and select “authorized for connection”
9. Select “Back” and “Exit” to finish the pairing procedure, and you can use the Car
kit with you 3650 phone now.
Note: Please turn on the automatic answer function of Headset and hands-free of your
mobile phone, then BH-005 can answer calls automatically, otherwise you may have to
push the “push button” on the BH-005 to answer the incoming calls.
CAUTION : DO NOT USE NORMAL BATTERIES, OR MIX WITH USED OR
OTHER BATTERY TYPES, MAY EXPLORED OR LEAK AND CAUSE PERSONAL
INJURY
PLEASE NOTE:
"The driver is ultimately responsible for the safe operation and control of their
vehicle at all times. You should never use a hand held phone, including sending or
reading text or picture messages, while driving . Research indicates that there is a risk to
safety when the driver of a motor vehicle is distracted and using a mobile phone while
driving can be a distraction. Vodafone strongly recommends that you use a hands free
solution when driving and, if you are in any doubt, that you find a safe place to pull over
and stop before making or taking a call."
Federal Communications Commission (FCC) Statement
15.21
You are cautioned that changes or modifications not expressly approved by the part
responsible for compliance could void the user’s authority to operate the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
You are cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
FCC RF Radiation Exposure Statement:
This Transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
/
