2. BLOTZ
  3. B20-ME-003

BLOTZ B20-ME-003, B20_ME_003 Assembly Instructions

  • Hello! I've reviewed the instructions for the Middle Eastern Building B20-ME-003 model. This document provides a detailed guide for assembling the model, including wall construction, roof placement, and other essential steps. I'm ready to answer your questions about the assembly process or specific steps outlined in the instructions. Let me know how I can help!
  • What kind of glue is needed?
    What kind of knife should be used?
    Do I need to glue the roof?
20mm Middle Eastern Building #3
B20-ME-003
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the two side walls and the front wall of the
building from the sprue.
Glue them together to form an “H” shape 9as shown
above) them attach them to the base using the guide
lines provided.
Take the rear wall and gateway from the sprue.
Glue them into position as shown.
Take the roof supports and door from the sprue.
Glue the door behind the opening then attach the
roof supports and shown.
Glue the trapdoor to the roof piece, then place 9do
not glue) the roof on top of the supports.
Glue the gateway pieces into position.
/