2. Christie
  3. HD10K-M
HD10K-M

Christie HD10K-M, HD6K-M, Roadster HD10K-M Operating instructions

  • Hello! I've reviewed the instruction sheet for the Christie M Series projector. This document provides essential guidance on how to properly affix the safety labels, including the AC Power Switch Location and Danger Hazardous Voltage labels. I'm ready to assist you with any questions you may have regarding the instructions or any related aspects of this document.
  • What labels are included?
    Where should the AC Power Switch location label be placed?
    Where should the Danger Hazardous Voltage label be placed?
Label Placement Instruction Sheet 1 of 2
020-100570-01 Rev. 1 (04-2010)
Label Placement
Instruction Sheet
INTRODUCTION
If not already equipped, two (2) new safety labels (included in this package) must be affixed to the outside
skin of your M Series projector – a Power Switch Location label and a Danger Hazardous Voltage label.
Please use the following placement instructions and accompanying diagram (Figure 1) when placing these
new labels onto your projector.
LABELS REQUIRED
xLabel AC Power Switch Location (PN 013-101549-01)
xLabel Danger Hazardous Voltage (PN 013-101546-01)
INSTRUCTIONS
1. Place the AC Power Switch location label directly below the bevel and in line with the licence label
as shown in Figure 1.
2. Place the Danger Hazardous Voltage label between the two center screws in the orientation shown in
Figure 1.
2 of 2 Label Placement Instruction Sheet
020-100570-01 Rev. 1 (04-2010)
DANGER
HazardousVoltage
AlwaysplacetheprojectorACpower
switchintheOFFpositionbefore
unpluggingtheAClinecord.
DANGER
Hazardous Voltage
Always place the projector AC power
switch in the OFF position before
unplugging the AC line cord.
AC Power
Switch Location
Danger Hazardous Voltage
Figure 1
/