Concord Eye-Q 3040AF
I am having difficulties installing the camera driver and software. What Should I
do?
If you encounter this issue, please uninstall the driver completely and restart you
computer. Please reinstall the driver again. It's recommended you download the latest
driver version from our website http://www.concord-
camera.com/support/downloads/downloads.htm.
There are two ways to uninstall drivers or software completely:
1.Uninstall the driver or software from Programs:
& From the Start button, click Programs and choose the camera model software and
driver.
& From the camera software folder, select the Uninstall Wizard. When asked if you
want to completely remove the program from your computer, answer Yes. A message
stating that the program was successfully removed is displayed.
& Click Start > Shut Down.
When the Shut Down dialog box is displayed, choose Restart.
& Click OK to restart your computer.
2. Uninstall the driver or software from the Control Panel:
& From the Start button, click Settings > Control Panel.
& Double-click Add/Remove Programs.
& Highlight the desired software and click the Change/Remove button.
& Proceed to the next step following the on-screen instructions.
& Click Start > Shut Down.
When the Shut Down dialog box is displayed, choose Restart. Click OK to restart your
computer.
Does the Concord Eye-Q 3040AF support Windows 98 First Edition?
This camera supports Windows 98 Second Edition and higher operating system.
Why doesn’t the flash fire?
Ensure that the flash is set to Auto Flash or Fill-in Flash. If the batteries are weak, the
flash will not be able to recharge and as a result, it is not able to fire. Please turn off the
camera and wait a few seconds before turning it on again. If the flash still does not fire,
please replace the batteries.
Concord Eye-Q 3040AF
After taking a picture or two, my camera suddenly turns off. Is there something
wrong with it?
There is nothing wrong with your camera. The camera has a built-in power saving
feature that turns the camera off after more than 2 minutes of inactivity (default
setting) to conserve battery power. The auto off time setting can be changed in the set
up menu.
Changing the Auto off Time Setting:
1. Set the camera to Camera Mode.
2. Press the Menu button to display the main menu.
3. Press until the Setup is highlighted.
4. Press to enter the Setup submenu.
5. In the Setup menu, press to highlight “Auto Off Time”.
6. Press to enter “Auto Off Time”. Press to highlight the time you want.
7. Press the OK button to save your selection.
How can I get better battery performance for my digital camera?
This camera comes with alkaline batteries. These batteries are universal, convenient,
and inexpensive. These alkaline batteries do not require a special battery charger and
they can be purchased anywhere. However, they are not the most efficient when it
comes to power.
• When power is in short supply, it is best to avoid the camera functions that
consume the most power.
1. Avoid using the LCD monitor when you want to extend the battery life.
2. Using the LCD monitor consumes the most battery power.
3. Use only the viewfinder for taking pictures.
4. Turning the zoom on and off forces the zoom lens to extend and retract with each
power cycle. Avoid using the zoom when possible.
5. Avoid using the flash.
6. Use an external card reader whenever possible.
7. Take advantage of external power sources whenever you can.
• Use rechargeable Nickel-Metal Hydride (Ni-MH) batteries. Have two sets of
batteries, one set in the camera and one charging or in reserve for when you need to
swap them out.
• Store charged spare batteries in the coolest place you can find (at or above freezing)
but be sure to bring cold batteries back up to room temperature before using them.
• Store and use your camera and batteries as close to room temperature as you can.
Note: Rechargeable batteries often get up to two times as many shots on a fresh
charge.
/