CONCORD Eye-Q 2100 FAQ

Brand: CONCORD

Model: Eye-Q 2100

Type: FAQ

Concord Eye-Q 2100

1. Does my camera have an audio function?

This model is not equipped with an audio function.

2. Is this camera compatible with Windows® XP?

Yes, the camera is compatible with Windows XP. However, since the

Windows XP logo certification has not been completed, a warning pop-up

message as illustrated below will be displayed during the software

installation. Please click on “Continue Anyway” to proceed with your

installation.

1. What is the rating of the AC adaptor?

The camera supports a 5V/2A AC adaptor. AC adaptors can be purchased

from computer and electronic specialty stores.

4. Why doesn’t the flash fire?

Ensure that the flash is set to Auto or Flash. If the batteries are weak, the

flash will not be able to recharge and as a result, it is not able to fire. Please

turn off the camera and wait a few seconds before turning it on again. If the

flash still does not fire, please replace the batteries.

Concord Eye-Q 2100

5. I am having difficulties installing the camera driver and software.

What Should I do?

If you encounter this issue, please uninstall the driver completely and

restart your computer. Please reinstall the software again. It’s

recommended you download the latest driver version from our website

http://www.concord-camera.com/support/downloads/downloads.htm.

There are two ways to uninstall drivers or software completely:

1.Uninstall the driver or software from Programs:

& From the Start button, click Programs and choose the camera model

software and driver.

& From the camera software folder, select the Uninstall Wizard. When

asked if you want to completely remove the program from your

computer, answer Yes. A message stating that the program was

successfully removed is displayed.

& Click Start > Shut Down.

& When the Shut Down dialog box is displayed, choose Restart. Click

OK to restart your computer.

2. Uninstall the driver or software from Control Panel:

& From the Start button, click Settings > Control Panel.

& Double-click Add/Remove Programs.

& Highlight the desired software and click the Change/Remove button.

& Proceed to the next step following the on-screen instructions. When

asked if you want to completely remove the program from your

computer, answer Yes. A message stating that the program was

successfully removed is displayed.

& Click Start > Shut Down.

& When the Shut Down dialog box is displayed, choose Restart. Click

OK to restart your computer.

CONCORD Eye-Q 2100 FAQ

CONCORD Eye-Q 2100 FAQ

Related papers

Other documents