Assembly Instructions
Item Number : 58175
19” 2U size rack-plate for 2pcs SEC-1212G/1223/1225G/1235G/2412G
The rack-plate is designed to integrate your power supply into a 19” 2U rack mount power
supply.
Please read the following instructions to ensure proper installation.
Tools required : Philips #2 screw driver
Hardware included : Rack-plate
1. Turn the power supply "Off" and unplug the AC power cord from the AC power source.
2. Unscrew the 4 small cover screws located on the sides of power supply cover.
Untwist the screws about 1 1/2– 2 strokes.
3. Align the screws on the side of the power supply with the grooves on the rack-plate.
4. Push the power supply very carefully into the grooves and slide the power supply to-
wards the front of the rack-plate. Be aware that the screws at the back of the side of
the power supply got into the groove as well.
5. Evenly tighten the 4 screws on the sides of the power supply to secure the power sup-
ply to the rack-plate.
6. Repeat this installation procedure for the 2nd power supply. However you will not be
able to tighten the front screw of the power supply located in the middle. The other 3
screws can be tightened.
7. You are now ready to use your power supply as a 19” rack mount power supply. .
/
