Enabling Devices 3060W User guide

Brand
Enabling Devices
Model
3060W
Type
User guide
For Technical Support:
For Technical Support:For Technical Support:
For Technical Support:
Call our Technical Service Department
Monday through Friday, 9 a.m. to 5 p.m. (EST)
1-800-832-8697
customer_support@enablingdevices.com
Lights & Vibration Somatosensory Tube
#3035
USER’S GUIDE
50 Broadway
Hawthorne, NY 10532
Tel. 914.747.3070 / Fax 914.747.3480
Toll Free 800.832.8697
www.enablingdevices.com
www.enablingdevices.comwww.enablingdevices.com
www.enablingdevices.com
Instant
InstantInstant
Instant
rewards!
rewards!rewards!
rewards!
Perfect for developing grasping skills, localizing sound
and teaching cause and effect. Simply pick up the tube
(#3035 and #3030), hold it in a vertical position and it
instantly rewards you with glowing lights and soothing
vibrations. Our version (#402) adds music. All use reliable
solid-state technology. Size: 2½"D x 12"L. Requires 2 AA
Batteries. Weight: ¾ lb.
OPERATING INSTRUCTIONS:
OPERATING INSTRUCTIONS:OPERATING INSTRUCTIONS:
OPERATING INSTRUCTIONS:
1. Remove the vinyl end cap with the small hole on the
top, by holding the tip of the cap and gently pulling
and turning. Only one end cap will come off, exposing
the battery compartment and speed controller.
2. Pull the battery sleeve out of the tube by round cutout
in its base.
3. Remove the black battery case cover by unscrewing
the Phillips head screw, then slide the cover off and
install two -AA batteries following proper (+) and (-)
markings. Replace cove and screw and slide sleeve
back in and reinstall the vinyl cap.
4. While holding the tube at an upright angle, adjust the
vibration speed control switch next to the round
cutout starting from right to left, settings are as
follows: HIGH/LOW/OFF vibration.
5. Reinstall the vinyl cover over the end of the tube.
Please Note: when re
Please Note: when rePlease Note: when re
Please Note: when re-
--
-installing th
installing thinstalling th
installing the battery sleeve
e battery sleeve e battery sleeve
e battery sleeve
make sure to slide it just until it lines up with the
make sure to slide it just until it lines up with the make sure to slide it just until it lines up with the
make sure to slide it just until it lines up with the
end of the clear tubing.
end of the clear tubing.end of the clear tubing.
end of the clear tubing.
6. Simply turn the Lights and Vibration Sensory Tube
Lights and Vibration Sensory TubeLights and Vibration Sensory Tube
Lights and Vibration Sensory Tube to
a vertical position to enjoy the soothing vibrations and
glowing lights.
IMPORTANT NOTES:
IMPORTANT NOTES:IMPORTANT NOTES:
IMPORTANT NOTES:
If the unit fails to operate, or operates incorrectly, the
following steps should be performed:
Check batteries to ensure proper installation. If the
unit still does not work correctly after the batteries are
reconnected, replace all the batteries.
The lights on t
The lights on tThe lights on t
The lights on the tube do not shut off immediately,
he tube do not shut off immediately, he tube do not shut off immediately,
he tube do not shut off immediately,
rather they fade out slowly once the tube is placed
rather they fade out slowly once the tube is placed rather they fade out slowly once the tube is placed
rather they fade out slowly once the tube is placed
horizontally.
horizontally.horizontally.
horizontally.
If you have any problems or questions about this unit or
any of our products, please call our Technical Assistance
Department at 1-800-832-8697.
Rev
Rev Rev
Rev 4/27
4/274/27
4/27/1
/1/1
/17
77
7
  • Page 1 1
  • Page 2 2

Enabling Devices 3060W User guide

Brand
Enabling Devices
Model
3060W
Type
User guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents