Golden Lighting 2117-BA2 CH-OP Operating instructions

Type
Operating instructions

This manual is also suitable for

IMPORTANT:
• ALLINSTALLATIONWORKSHOULDBEDONEBYACCREDITEDPROFESSIONAL.
• SHUTOFFPOWERSUPPLYATFUSEORCIRCUITBREAKER!
• USEONLYTHESPECIFIEDBULBS.DONOTEXCEEDTHEMAXIMUMWATTAGE!
PREPARING FOR INSTALLATION
Removeallofthecontentsfromthecarton.Seetheimportantnotesabove.Removetheoldxturefromthewall,includingtheold
mountingstrap.
1.Takethemountingstrapassemblyfromthepartsbag.Mountingstrap(B)containsthreadedholes.Twoofmountingscrews(A)
shouldbeattachedtomountingstrap(B).Youmayneedtotightennuts(C)thatholdthesescrewsinplace.Ifthescrewsarenot
attached,pleaseholdbackplate(F)againstmountingstrap(B).Lineuptheholesinbackplate(F)withtheholesinmountingstrap
(B)andinsertmountingscrews(A)intomountingstrap(B)sothatmountingscrews(A)protrudethroughtheholesinbackplate(F)).
Mountingscrews(A)arelong,sopleasetestbackplate(F)againstthemountingstrapandpracticethreadingdeconuts(G)onto
mountingscrews(A)toseehowfaryoushouldinsertthescrews.Removethedeconutsandbackplate.Tightennuts(C)ontomounting
screws(A)toholdthescrewsinplace.
2.Placemountingstrap(B)overthejunctionboxsothatmountingscrews(A)arehorizontal,andinalignmentwiththeholelocations
onthexture’sbackplate(F).Securemountingstrap(B)tothejunctionboxwithmountingscrews(D)andascrewdriver.Tightenthe
screwssecurely.
CONNECTING THE WIRES
3.Haveanassistantsupportthexture’sweightwhilecompletingthewiring.Refertothewiringdiagrambelowandattachthexture’s
wirestothepowersupplywiresfromthejunctionbox.ConnectHottoHot,NeutraltoNeutral,andGroundtoGround.Twisttheends
ofthewirepairstogether,andthentwistonawireconnector.Makesurealltwistsareinthesamedirection.Ifthereisnohouseground
wirecomingfromthejunctionbox,locategroundscrew(E)onthemountingbracket/mountingstrapandwrapthexture’sground
wirearoundthegroundscrew.Useascrewdrivertotightenthetopofgroundscrew(E)ontothewiresandintothemountingbracket/
mountingstrap.Tuckthewiresintothejunctionbox.
FINISHING THE INSTALLATION
4.Placethexture’sbackplate(F)overmountingscrews(A)sothatmountingscrews(A)protrudethroughtheholesinthefrontof
backplate(F).Threaddeconuts(G)ontomountingscrews(A).Twistuntilthebackplateofthextureissnugagainstthewall.
5.Screwdecorativecap(N)intoarm(M).Pushpeg(O)intodecorativecap(N)andcoverwithbottomcap(Q)andbottomnial(P).
Slideglass(I)overthesocketandsecureinplacewithspacer(J)andsocketring(K).
6.Installlightbulbs(notincluded)inaccordancewiththexture’sspecications.Donotexceedthemaximumrecommendedwattage.
Yourinstallationisnowcomplete.Turnonthepowerandtestthexture.
AssemblyInstructions:2117-BA2, BA3 (Vanna)
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.
A
B
C
D
F
E
G
P
Q
O
N
M
H
J
I
K
Front View
For Customer Service, please
contact the place of purchase.
How to Identify the Fixture’s Wires
Hot Neutral Ground
Smooth
Ribbed
Bare Metal,
Green, or
Green Inner
Thread
Black
White
Black Inner
Thread
White Inner
Thread
House Wires
Fixture Wires
Hot
  • Page 1 1

Golden Lighting 2117-BA2 CH-OP Operating instructions

Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI