Rubbermaid FG3R18FTWHT Installation guide

Brand: Rubbermaid

Model: FG3R18FTWHT

Type: Installation guide

This manual is also suitable for

Insert into center slot

Start by inserting the brackets in the desired location

on the Fasttrack uprights. Insert the top tabs ﬁrst and

then lock it in by pushing it down towards the wall.

Ensure that the bottom tabs are securely inserted into

the slots on the upright. (Figure 1)

STEP 1

STEP 2

STEP 3

STEP 4A

STEP 4B

STEP 5

Place your shelf on the brackets so that the front of the

shelf is resting on the front of the brackets. (Figure 2)

Shelving & Bracket Install Tips

Follow these steps to properly install wire shelving into Fasttrack closet brackets

Grab the rear of the shelf and ﬂex it up slightly while

holding the front of the shelf against the front of the

brackets. (Figure 3)

Line up the shelf with the slots on the bracket and place

the center wires of the shelf into the slots. (Figure 4A & 4B)

For deep shelving (16” or 20”), secure the shelf within

the slots in two places. (Figure 4B)

Once the shelf is in the slots, push the shelf towards the

wall to secure the back wire into its slot. (Figure 5)

Your shelf is now installed. Repeat this process for any

additional shelves you wish to place in this system.

(Figure 1)

(Figure 2)

(Figure 3)

(Figure 4B-16 inch shelf )

(Figure 4A-12 inch shelf )

(Figure 5)

Insert into rear slot

Insert into both slots

Rubbermaid Incorporated, Huntersville, NC USA 28078-1801

U.S.A. 1-888-895-2110 Canada 1-866-595-0525

www.rubbermaid.com

Rubbermaid FG3R18FTWHT Installation guide

Brand: Rubbermaid

Model: FG3R18FTWHT

Type: Installation guide

This manual is also suitable for

Download PDF

report

Rubbermaid FG3R18FTWHT Installation guide

This manual is also suitable for

Rubbermaid FG3R18FTWHT Installation guide

Related papers

Other documents