Minelab 3011-0099 Operating instructions

ConneCting the Coil

Plug the two rubber washers into the holes

on either side of the lower shaft yoke.

Slide the yoke into the yoke bracket on top

of the coil. Ensure that the spring loaded pin

in the lower shaft is underneath.

Insert the plastic bolt through the yoke and

the yoke bracket.

Fasten with the plastic wing nut provided,

being careful not to damage the thread

of the bolt by over-tightening. This may

need to be loosened to adjust the coil to a

comfortable detecting angle.

The coil cable is directly wired into the coil

and is not removable.

Any attempt to disconnect this cable will

void your warranty.

This manual is also suitable for

Download PDF