Yamaha MY8-AEB User manual

Category
Video switches
Type
User manual

Yamaha MY8-AEB is a Mini-YGDAI I/O interface card designed for use with Yamaha digital mixers and other pro audio equipment. It offers eight channels of analog audio I/O, with four XLR/TRS combo inputs and four XLR outputs. The card also features a coaxial S/PDIF input and output, allowing for digital audio connectivity. The MY8-AEB can be used to expand the I/O capabilities of a compatible Yamaha device, providing additional inputs and outputs for connecting microphones, instruments, and other audio sources.

Yamaha MY8-AEB is a Mini-YGDAI I/O interface card designed for use with Yamaha digital mixers and other pro audio equipment. It offers eight channels of analog audio I/O, with four XLR/TRS combo inputs and four XLR outputs. The card also features a coaxial S/PDIF input and output, allowing for digital audio connectivity. The MY8-AEB can be used to expand the I/O capabilities of a compatible Yamaha device, providing additional inputs and outputs for connecting microphones, instruments, and other audio sources.

2
Thank you for purchasing an I/O interface card for use with Yamaha digital audio equipment.
Refer to the respective owner’s manual for installation information.
As well as securing the card in place, the fixing screws act as an electrical ground, so
be sure to screw them in tightly.
1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!
This product, when installed as indicated in the instructions con-
tained in this manual, meets FCC requirements. Modifications not
expressly approved by Yamaha may void your authority, granted by
the FCC, to use the product.
2. IMPORTANT: When connecting this product to accessories and/
or another product use only high quality shielded cables. Cable/s
supplied with this product MUST be used. Follow all installation
instructions. Failure to follow instructions could void your FCC
authorization to use this product in the USA.
3. NOTE: This product has been tested and found to comply with the
requirements listed in FCC Regulations, Part 15 for Class “B” digi-
tal devices. Compliance with these requirements provides a rea-
sonable level of assurance that your use of this product in a
residential environment will not result in harmful interference with
other electronic devices. This equipment generates/uses radio fre-
quencies and, if not installed and used according to the instruc-
tions found in the users manual, may cause interference harmful to
the operation of other electronic devices. Compliance with FCC
The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries.
* This applies only to products distributed by YAMAHA CORPORATION OF AMERICA. (class B)
regulations does not guarantee that interference will not occur in all
installations. If this product is found to be the source of interfer-
ence, which can be determined by turning the unit “OFF” and “ON”,
please try to eliminate the problem by using one of the following
measures:
Relocate either this product or the device that is being affected by
the interference.
Utilize power outlets that are on different branch (circuit breaker or
fuse) circuits or install AC line filter/s.
In the case of radio or TV interference, relocate/reorient the
antenna. If the antenna lead-in is 300 ohm ribbon lead, change the
lead-in to co-axial type cable.
If these corrective measures do not produce satisfactory results,
please contact the local retailer authorized to distribute this type of
product. If you can not locate the appropriate retailer, please con-
tact Yamaha Corporation of America, Electronic Service Division,
6600 Orangethorpe Ave, Buena Park, CA90620
FCC INFORMATION (U.S.A.)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
PRECAUTIONS
WARNING
Failure to observe the following warnings may lead to
fatality or serious injury from fire or electric shock.
Before installing the card, you must refer to the owner’s manual
of the host device or to the Yamaha website (“Guidance on the
use of Mini-YGDAI cards” page) to verify that your host device
supports this card, and to verify the number of cards that can
be installed in combination with other Yamaha or third-party
cards.
Yamaha Pro Audio website: http://www.yamahaproaudio.com/
Do not attempt to disassemble or modify the card. Do not apply
excessive force to board connectors or other board
components. (Mishandling of board may lead to shock, fire
hazard, or equipment failure.)
Be sure to disconnect the power cable from the main unit before
installing this card (to eliminate shock hazard).
CAUTION
Failure to observe the following precautions may lead to
personal injury, or may result in damage to equipment or
other property.
Do not touch the board’s metallic leads (pins) when handling
the card. (Pins are sharp and may cause hand cuts.)
The card is electrostatic-sensitive. Before handling the card,
you should briefly touch the main unit’s metal casing with your
bare hand so as to drain off any static charge from your body.
* The company names and product names in this Owner's
Manual are the trademarks or registered trademarks of their
respective companies.
* Illustrations herein are for explanatory purposes only, and
may not match actual appearance during operation.
Yamaha assumes no responsibility for data loss, equipment
damage, or injury caused by inappropriate handling or
usage.
5
PA L
44.1 K
ON
UP
4%
REF V
RSVD
NTSC
48 K
OFF
DOWN
0.1%
AE
IN7/8
1 2
4
5
3
REF
VIDEO
INPUT
OUTPUT
I/O INTERFACE CARD MODEL MY8-AEB
MADE IN JAPAN
7/8 5/6 3/4 1/2
7/8 5/6 3/4 1/2
12
The MY8-AEB is an eight-channel digital input/output card that complies with the AES 3id-1995 standard. It provides video
input jacks that allow the host device in which the MY8-AEB is installed to be synchronized to a video signal.
Panel Switches
Panel
1
REF VIDEO jack
This is a video input jack used to generate a word clock
synchronized to the video signal. It has the capability of
maintaining the word clock even if the video signal is
interrupted. In order to use this word clock, set switch
4
to the
REF V position.
2
INPUT/OUTPUT jacks
These are AES 3id-1995 compliant input and output jacks.
Switches
Set these switches as appropriate for your situation and for the device
to which this unit is connected.
1
Video Signal
2
Basic Fs
3
Fs Factors
Do not input signals other than in this format.
Doing so may damage the device.
Mode Position
PA L PA L
NTSC NTSC
Mode Position
44.1 kHz 44.1 K
48 kHz 48 K
Mode (Fs / Basic Fs)
Position
OFF/ON DOWN/UP 0.1% / 4%
25/24 (+4%)
ON UP
4%
1001/1000 (+0.1%) 0.1%
1 (Basic Fs) OFF
1000/1001 (–0.1%)
ON DOWN
0.1%
24/25 (–4%) 4%
4
Ch7/8 Word Clock Source
This switch selects the word clock source that is provided as Ch 7/8 of the
host device in which the MY8-AEB is installed.
If this switch is set to the REF V position, you will be able to use the
word clock that is generated from the video signal. Use switches
1
3
to
specify the conditions for the word clock that is generated.
NOTE:
If this is set to REF V, the word clock will continue to be provided
from the MY8-AEB even if the video signal is interrupted or if a
problem occurs with the input waveform. However, the word clock
status indicator for channel 7/8 of the host device slot in which the
MY8-AEB is installed will display an error such as SYNC ERROR to
indicate that a problem has occurred.
If this is set to REF V and there is no signal being input to INPUT 7/8,
the channel status indication (e.g., emphasis) for that channel of the
host device may not be displayed correctly.
5
Reserved
Leave this switch permanently set to the AE position for use.
Host devices in which the MY8-AEB can be
installed
NOTE:
•For the latest information on host devices in which the MY8-AEB can be
installed, refer to the Yamaha Pro Audio website.
Yamaha Pro Audio global web site:
http://www.yamahaproaudio.com/
Mode Position
Synthesized from REF VIDEO REF V
INPUT 7/8 IN7/8
Model name
# of Usable
cards
Model name
# of Usable
cards
DME32 3 01V96 1
DIO8 8 DME24N 1
DM2000 6 DME64N 4
02R96 4 PM5D/PM5D-RH 4
DM1000 2 M7CL-48/32 3
WG00240 512IPCP1.2-01A0
U.R.G., Pro Audio & Digital Musical Instrument Division, Yamaha Corporation
©2005 Yamaha Corporation
Printed in Japan
Yamaha Manual Library
http://www.yamaha.co.jp/manual/
This document is printed on chlorine free
(ECF) paper with soy ink.
For European Model
Purchaser/User Information specified in EN55103-1 and EN55103-2.
Conformed Environment: E1, E2, E3 and E4
Für das europäische Modell
Kunden-/Benutzerinformation nach EN55103-1 und EN55103-2.
Entspricht den Umweltschutzbestimmungen: E1, E2, E3 und E4
Pour le modèle européen
Informations pour l’acheteur/usager spécifiées dans EN55103-1 et EN55103-2.
Environnement adapté: E1, E2, E3 et E4
Modelo para Europa
Información sobre el comprador/usuario especificada en EN55103-1 y EN55103-2.
Entorno de acuerdo con: E1, E2, E3 y E4
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12

Yamaha MY8-AEB User manual

Category
Video switches
Type
User manual

Yamaha MY8-AEB is a Mini-YGDAI I/O interface card designed for use with Yamaha digital mixers and other pro audio equipment. It offers eight channels of analog audio I/O, with four XLR/TRS combo inputs and four XLR outputs. The card also features a coaxial S/PDIF input and output, allowing for digital audio connectivity. The MY8-AEB can be used to expand the I/O capabilities of a compatible Yamaha device, providing additional inputs and outputs for connecting microphones, instruments, and other audio sources.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI