ADC 5110E Series Use, Care & Maintenance

Pocket Diagnostic Instruments

Use, Care, & Maintenance

2

Thank you for choosing an ADC

®

Diagnostic set. We’re proud of the care and quality that

goes into the manufacture of each and every diagnostic instrument that bears our name.

Every component has been carefully designed to maximize performance. This booklet

refers to both Otoscope and Ophthalmoscope sets (Models 5110N Series, 5110E, 5111N

Series, 5112N Series).

Device Description and Intended Use

Ophthalmoscope attachment (5110N Series, 5110E, 5112N Series)

The ophthalmoscope is a handheld, battery-powered device containing illumination and

viewing optics intended to examine the media (cornea, aqueous, lens, and vitreous), the

retina, blood vessels, optic nerve, and other structures of the eye. It is intended to be used

by a trained healthcare professional.

Otoscope Attachment (5110N Series, 5110E, 5111N Series)

A handheld battery powered device with magnifying system that provides illumination of

the ear canal and tympanic membrane.

Latex Statement - This device and all accessories are not made with natural rubber latex.

This device should be used by a trained healthcare professional.

Contraindications

The use of this device is contraindicated in patients who have already received prolonged

or intense light exposure, especially if the patients are infants, aphakes, or persons with

diseased eyes. Excessive exposure to light may result in patient injury. See warnings for

additional information.

3

Symbol Definition

Attention. Read Operating Manual

for Cautions and Instructions

for Use.

Not made with natural rubber latex

Conforms to EU Standards

Symbol Definition

Authorized European

Represenative’s Information

Manufacturer’s Information

TYPE B. Indicates this is a product

with Type B applied parts

Do not dispose of this product

as unsorted municipal waste

General Warnings

A warning statement in this manual identifies a condition or practice which, if

not corrected or discontinued immediately, could lead to patient injury, illness, or

death.

CAUTION: Because prolonged intense light exposure can damage the retina, the use of

the device for ocular examination should not be unnecessarily prolonged, and the bright-

ness setting should not exceed what is needed to provide clear visualization of the target

structures.

The retinal exposure dose for a photochemical hazard is a product of the radiance and

the exposure time. If the value of radiance were reduced in half, twice the time would be

needed to reach the maximum exposure limit.

While no acute optical radiation hazards have been identified for direct or indirect oph-

thalmoscopes, it is recommended that the intensity of light directed into the patient's eye

be limited to the minimum level which is necessary for diagnosis. Infants, aphakes and

persons with diseased eyes will be at greater risk. The risk may also be increased if the

person being examined has had any exposure with the same instrument or any other oph-

thalmic instrument using a visible light source during the previous 24 hours. This will

apply particularly if the eye has been exposed to retinal photography.

Symbol Definitions

The following symbols are associated with your diagnostic instrument.

LATEX

4

CAUTION: Do NOT immerse the battery handle in liquid. Consult the cleaning and dis-

infection instructions for each part for further information about cleaning and disinfecting

this product. Never clean or disinfect any device with batteries in it.

CAUTION: Federal law restricts this device to sale by or on the order of a physician or li-

censed healthcare practitioner.

CAUTION: Turn off instrument when not in use. Avoid powering on without an instrument head

attached. When storing this device for extended periods of time, remove the batteries.

WARNING: The carrying cases provided with these devices are intended for long term

storage or transport between facilities or when shipping devices to and from ADC’s facility

for repair or servicing. Carry cases (including internal liners) can NOT be cleaned or dis-

infected and should be safely discarded if contaminated. Do not carry the case into a con-

taminated environment.

WARNING: When replacing lamp, allow lamp to cool for five minutes before handling.

WARNING: Only the approved sterilization method included in this IFU has been vali-

dated for this device or its corresponding components. Any other sterilization method

may compromise the safety and effectiveness of this device. (This includes steam steril-

ization.)

WARNING: Do NOT place devices or accessories back into carrying case after use on a

patient without first cleaning/disinfecting the device/accessories as described in the clean-

ing and disinfection section of this manual. Carry case liners can NOT be cleaned or dis-

infected and should be discarded if contaminated.

WARNING: Use of any accessories or materials not indicated in the user's manual can

degrade the minimum safety of the equipment.

WARNING: Only replace listed accessories (attachments), lamps, or batteries for the device.

WARNING: During use metal components near instrument head can become warm. This

is especially true if device is on for extended periods of time. Do not leave device on when

not in use.

WARNING:The light emitted from this instrument is potentially hazardous. The longer the

duration of exposure, the greater the risk of ocular damage. Exposure to light from this

instrument, when operated at maximum intensity, will exceed the safety guideline after

3 minutes and 47 seconds. Exposure times are cumulative for a 24 hour period.

5

Otoscope Parts and Assembly

The Pocket Otoscope consists of a “AA” battery handle (#5160N), fiberoptic Otoscope

Instrument Head (5120N Series), with attached movable viewing lens, and disposable

specula (2.75mm and 4.25mm).

Removing and Attaching the Instrument Head

Pocket otoscope heads are threaded and can be removed by ro-

tating the threaded connection counterclockwise, or attached by

rotating the threaded connection clockwise.

Viewing Lens

To move during an examination, turn the lens bezel clockwise to

lift up. To reposition, reverse procedure.

Attaching the Disposable Specula

Push the flanged end of the desired speculum onto the chrome

socket and twist counterclockwise to engage. Reverse

procedure to remove and discard after each use.

NOTE: Otoscope must be used with specula.

Pneumatic Otoscope

To perform, insert tapered end of insufflator fitting (5121N) sold

separately, into hole on side of Otoscope head. Attach optional bulb

assembly (5122N) sold separately.

6

Ophthalmoscope Parts and Assembly

The Pocket Ophthalmoscope consists of a “AA” battery handle (5160N) and Ophthalmoscope

instrument head (5140N Series).

OFF

ON

Aperture Selection

This unit is equipped with 5 internal apertures - small, large, semi-

circle, red-free, and fixation. To select, rotate the aperture selection

wheel at the front of the instrument head.

Corrective Lens Selection

This unit is equipped with 19 corrective lenses from +20 to -20

diopters (negative lenses in red). To select, rotate the

corrective lens selection wheel at either side of the instrument

head. Selected lenses can be viewed in the lighted panel on prac-

titioner side of instrument.

Turning Instrument On

To illuminate, slide the on/off switch located on the battery handle

pocket clip away from the instrument head. Slide the switch in the op-

posite direction to turn off.

Replacing Lamp

Remove the Instrument head by turning counterclockwise. Grab

end of lamp from inside base of instrument head and remove. Re-

place with new lamp, taking care not to touch glass, and align

lamp metal guides on side of lamp with grooves in lamp socket.

(Ophthalmoscope heads only).

NOTE: Allow lamp to cool for five minutes before handling if de-

vice has been recently used.

*NOTE: Otoscope LED lamp cannot be replaced, must order new

head with lamp.

7



Lamp Replacement Part Numbers

Lamp Type Otoscope Ophthalmoscope

Hal/Xenon 5111N-4 5112N-4

LED 5120NL* 5112NL-4

Battery Replacement

This unit requires 2 “AA” batteries. For best performance, we

suggest alkaline batteries. To replace, remove the battery cap at

the base of the handle by turning counterclockwise and replace

batteries, taking care to observe correct polarity.

NOTE: This instrument should be turned OFF when not in use.

If storing for extended lengths of time, remove batteries

completely.

Handle Care and Maintenance

Periodically check the condition of both the batteries, making sure there is no sign

of corrosion or oxidation. Always replace BOTH batteries. Alkaline batteries are

recommended. Remove batteries from handle if instrument will not be used for

an extended period of time.

Cleaning and Disinfection

Basic Cleaning Procedure for Battery Handles,

Otoscope and Ophthalmoscope Heads

To clean the exterior of the device, prepare a 70% isopropyl alchohol solution and soak

a lint-free cloth. Wipe down the exterior of the ophthalmoscope head and handle, clean-

ing all external surface areas. Care should be taken to prevent excess liquid from seep-

ing into the components.

8

Isopropyl alchohol may be substituted with commonly used, EPA-registered hospital

disinfectant wipes for cleaning purposes if desired. Please refer to the directions

provided by the manufacturer of the wipes for appropriate instructions for use to ensure

effective contact time between the wipe and the device.

It is important to note that solution residue on the magnifying lenses may decrease de-

vice performance. All excess cleaning fluids must be carefully wiped clean if these sur-

faces are cleaned. The lenses of the instrument head may be cleaned with a lint-free

cloth or lens paper.

Steris Sterilization Processes

This product has been validated with the V-PRO 1 Standard Cycle; V-PRO 1 Plus

Lumen and Non Lumen Cycles; V-PRO maX Lumen, Non Lumen, and Flexible

Cycles; V-PRO 60 Lumen and Non Lumen Cycles using the V-PRO 60 Low

Temperature Sterilization System with VAPPROX® HC Sterilant and V-PRO maX Low

Temperature Sterilization System.

Disposable Specula Cleaning/Disinfection Instructions

Disposable specula should not be cleaned or disinfected in any way. Disposable spec-

ula are single patient use only and must be discarded after use. Disposable specula

should not be used if they appear to be visibly contaminated or have accidentally come

into contact with contaminated materials prior to use.

Troubleshooting

The following guidelines should be used to determine if your device has reached its

end of life or requires servicing. If the corrective actions described in this section do

not resolve your issues, please see the warranty section of this manual to have your de-

vice serviced.

9

Otoscope and accessories Troubleshooting Guide

Trouble Area

No light output

Instrument head will not

connect

Possible Cause

Lamp burned out

Wrong Lamp Installed

Batteries are depleted

Lamp not fully inserted

Thread/connection is

damaged

Wrong specula used

Corrective Action

Replace the lamp

Replace with fresh “AA”

batteries

Re-insert lamp

Service required

Use only Welch Allyn rand

or compatible

Corrective Action

Service required

Clean with lint free cloth

Service required

Replace the lamp

Replace with fresh “AA”

batteries

Service required

Trouble Area

Specula will not attach

properly

Loose or misaligned

magnifying lens

Poor or obstructed view

through lens

Dim light output

Visible corrosion on

instrument or accessories

Possible Cause

Specula mount is

damaged

Lens mount is

damaged

Lens is dirty

Lens is damaged

Lamp near end of

useful life

Batteries are depleted

Damage from

excessive moisture

10

Corrective Action

Rotate Aperture dial

Replace the lamp

Replace with fresh “AA” bat-

teries

Re-insert lamp

Service required

Move aperture dial to the full

detent position

Replace the lamp

Replace with fresh “AA” bat-

teries

Service required

Ophthalmoscope Troubleshooting Guide

Trouble Area

No light output

Instrument head will not

connect

Spot is not centered

Dim light output

Aperture or lens wheel will

not turn or does so with

difficulty

Visible corrosion on

instrument

Possible Cause

Aperture dial is between

positions

Lamp burned out

Wrong lamp installed

Batteries are depleted

Lamp not fully inserted

Thread/connection is

damaged

The aperture dial is not

centered

Lamp near end of useful

life

Batteries are depleted

Dirt in or damage to

mechanism

Damage from excessive

moisture

11

Environment

Transportation / Storage: -20°C to +49°C (-4°F to 120.2°F)

Relative Humidity: 95 %

500 hpa – 1060 hpa, Altitude

Environmental Operating Range: 10°C to 49°C (50°F to 120.2°F)

RH 95 % (Max)

500 hpa – 1060 hpa, Altitude

Max. Operating: 35°C (95°F)

LIMITED WARRANTY

American Diagnostic Corporation (ADC

®

) warrants its products against de-

fects in materials and workmanship under normal use and service as

follows:

1. Warranty service extends to the original retail purchaser only and commences

with the date of delivery.

2. The instruments are warranted for one year. The LED lamps are warranted for life.

What is Covered:

Repair, or replacement of parts, and labor.

What is Not Covered:

Transportation charges to ADC

®

. Damages caused by abuse, misuse, accident,

or negligence. Incidental, special, or consequential damages. Some states do

not allow the exclusion or limitation of incidental, special, or consequential

damages, so this limitation may not apply to you.

12

To Obtain Warranty Service:

Devices should be contained in their transport/storage cases when being

returned to ADC

®

to ensure that they are not damaged during transport and

handling. Do not ship contaminated devices or storage cases to ADC

®

’s fa-

cility.

Send item(s) postage paid to ADC

®

, Attn: Repair Dept., 55 Commerce Dr.,

Hauppauge, NY 11788. Please include your name and address, phone no.,

proof of purchase, and a brief note explaining the problem.

Implied Warranty:

Any implied warranty shall be limited in duration to the terms of this warranty

and in no case beyond the original selling price (except where prohibited by

law).

This warranty gives you specific legal rights and you may have other

rights which vary from state to state.

To Register Your Product,

visit us at

www.adctoday.com

and follow the links

ADC

55 Commerce Drive

Hauppauge, NY 11788

ADC (UK) Ltd.

Unit 6, PO14 1TH

United Kingdom

Inspected, assembled and

packaged in the U.S.A.

Components made in Dubai

tel: 631-273-9600

toll free: 1-800-232-2670

fax: 631-273-9659

www.adctoday.com

info@adctoday.com

IB p/n 9362-00 rev 7

Printed in the U.S.A.

ADC 5110E Series Use, Care & Maintenance

This manual is also suitable for

ADC 5110E Series Use, Care & Maintenance

Related papers

Other documents