2. ADC
  3. 9003BAT

ADC 9003BAT Installation guide

  • Hello! I've reviewed the user manual for the e-sphyg3 9003BAT blood pressure monitor, specifically regarding the high-capacity battery installation. I can assist with questions about the device, powering it off, battery replacement, and charging procedures mentioned in this document.
  • How do I power off the device before replacing the battery?
    What tool is required to remove the back cover?
    What should I do with the old battery?
    How will I know when the battery is fully charged?
High-Capacity Battery Installation
Press On/Off switch at back
of unit to power off the unit.
Unplug power adapter socket
from the back of the unit.
Remove both screws with
a Philips screw driver.
Slide out back cover.
1
2
Remove the existing battery
power pack.
Please do not dispose of battery
in municipal waste.
3
#9003BAT
Slide in the battery cover back into
position and replace screws.
Plug in power adapter socket at
back of device and plug into wall
outlet. Charge battery until re-
charge indicator on main unit
turns green.
5
Download full manual at www.adctoday.com/esphyg3
6
American Diagnostic Corporation
55 Commerce Drive
Hauppauge, NY 11788 USA
1-800-ADC-2670
www.adctoday.com
IFU p/n: 93-9003BAT-00 rev 0 (09/23/2021)
Insert new battery power pack.
Make sure exposed battery
wires are tucked underneath
the battery power pack so that
the battery cover can slide
back on.
4
/