2. Fishbone Offroad
  3. FB25106

Fishbone Offroad FB25106 Installation guide

  • Hello! I have reviewed the installation instructions for the FISHBONE OFFROAD TJ Wrangler Flashlight Mount. This document provides a step-by-step guide on how to install a flashlight mount under the front seat of a jeep, utilizing existing seat bolts and requiring only a 13MM socket and a torque wrench. I'm ready to answer your questions about installing or using this mount.
  • What tools are required for the installation?
    What type of flashlight does the mount fit?
    What is the torque for securing the seat bolts?
FB25106
Jeep® TJ Wrangler
Front Seat Flashlight Mount
2510600
REQUIRED TOOLS
13MM Socket
Torque Wrench
KIT CONTAINS
Flashlight mount
QTY
1
1. REMOVE SEAT BOLTS
Locate the two front-most seat bolts on either the
driver or passenger side. ………………………………………
Remove them with a 13MM Socket.
2. INSTALL FLASHLIGHT MOUNT
Place the mount over the bolt holes. ………………….
Secure it by replacing the seat bolts with a torque of
35 ft-lbs. ………………………………………………………………..
FB25106
Jeep® TJ Wrangler
Front Seat Flashlight Mount
2 2510600
3. INSTALL FLASHLIGHT
Secure your flashlight of choice into the brackets. It
will fit any D-cell battery light. ………………………………
ENJOY YOUR NEW TJ FLASHLIGHT MOUNT!
/