2. BLOTZ
  3. B28-ST-133

BLOTZ B28-ST-133 Assembly Instructions

  • Hello, I've reviewed the instructions for the Pit / Pool B28-ST-133 model from BLOTZ. This document outlines the assembly process, including gluing the semi-circles to the base and adding the top ring. I'm ready to answer any questions you have about constructing this 28mm scale miniature.
  • What type of glue is required for assembly?
    What tools are needed?
    What should I do to hold pieces in place while glue dries?
28mm Pit / Pool
B28-ST-133
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Take all the pieces from the sprue.
Glue two of the semi-circles to the base as shown,
aligning them with the circle etched into the base.
Stick the other two semi-circles on top of the first pair,
aligning the notches (see pic)
Glue the top ring into place so it slightly overhangs
on all sides.
The finished Pit / Pool
/