Board Diagram
Please check the following items after open the package. If it's missing, please contact the
dealer.
PoE Splitter
User Manual
1PCS
1PCS
Package List
PoE Splitter is compliant with IEEE802.3af standard, which can split data and power from
PoE signal. It perfect match camera enclosure and can split Ethernet and power from
ethernet cable for these device which can not support PoE. It can work with standard PoE
Switch or PSE device, compatible with mid-span and end-span, output 12V/1.1A power by
DC terminal, It is widely used in security surveillance and network project.
Feature
PoE Splitter
IEEE 802.3af Power over Ethernet Standard Compliance;
Compatible with mode A (End-Span) and mode B(Mid-Span);
12V /1.1A DC Power Output;
Excellent circuit isolation protection;
More than 82% conversion efficiency.
PoE Splitter
12
VerA 1.0
User Manual
连接接 口
Specification
Support Mode A (End-Span) and Mode B (Mid-Span)
Cat5/5e/6 Standard Network Cable
3 level ,Standard:IEC61000-4-2
3 level ,Standard:IEC61000-4-5
Humidity (Non-Condensing)
连接接 口
Trouble Shooting
Please find the following solution when the device doesn't work
Please confirm if the installation is correct;
Please confirm if the RJ45 cable order in accordance with the EIA/TIA568A or 568B industry
standards;
The maximum output consumption of the PoE port can't exceed 13W, please do not
connect the network device which consumption is more than 13W;
Please replace a normal device with a failure one to check if the device is broken;
If the problem still exists, please contact the factory.
Specifications suject to change without notice.
To Camera
Date/Power Input,
to PSE
PoE
DC OUT,
to Camera
DC OUT