Voyager JPORT User manual

JPORT Installation Instructions

Existing Radio

(Not Included)

1. Choose a mounting location on the dashboard that will allow enough room

behind the dash to run the JPORT cables to the existing car radio.

2. Drill a 3/4" hole in the dashboard.

3. Remove the hexagonal nut from the JPOR T

4. Insert the RCA cable ends through the hole in the dashboard from the front.

5. Replace hexagonal nut on the back side of the dashboard

and secure the JPORT to the dashboard.

6. Plug the RCA cables into the RCA-IN jacks on your existing car radio.

7. Plug a device with a 3.5 mm jack into the JPORT to test the connections.

8. Replace the dashboard components.

Radio's

Auxilliary Input

JPORT

White Washer

Hexagonal Nut

Dashboard

3.5 mm Jack

MP3 Player

(Not Included)

4 - Foot Cable with 3.5mm Male Jacks (Included)

Made in China/Printed in China

3/4 Inch

Recommended Size

for Mounting Hole