. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1-16 Overview
1.6 Keyboard Hot Keys
The hot keys are used to set up and control the computer. These keys are activated by
holding down the Fn key and pressing the desired function key. The following table
shows each hot key sequence and describes its function:
fn
+
Function
esc
Places the computer in Standby Mode.
F1
Sets the computer’s operating mode to maximize battery life. A single beep is emitted when
the computer switches to this operating mode. If the computer is restarted, the system return
to the settings contained in the System Setup Program.
F2
Sets the computer’s operating mode to maximize performance. Two beeps are emitted when
the computer switches to this operating mode. If the computer is restarted, the system return
to the settings contained in the System Setup Program.
F3
Used during Power Up Self-Test (POST) to enter the System Setup Program.
F4
Enables and disables the computer’s external display port and the LCD display. There are three
display modes:
LCD Display
LCD Display and External Monitor (simulscan)
External Display
Each time this hot key combination is pressed, the computer changes to the next display
setting.
Reserved for future use.
Enables the Keyboard/Mouse Lock. To use this feature, a user password must be set. When
Keyboard/Mouse Lock is enabled, the Enter Password prompt will appear on the screen and
the Caps Lock icon found on the LCD Status Display will blink. Enter the user password t
disable the Keyboard/Mouse Lock.
F7
Toggles the system sound between mute and on.
F8
Enables and disables the keyboard’s embedded key pad.
continued