16
8. Function knob:
a. PROG: to set the desired auto on time.
b. AUTO ON: auto-on feature to program the starting time of the
brew cycle.
c. AUTO OFF: auto-o feature up to 38 minutes after brew cycle
is nished.
d.
button: to start the brew cycle directly.
e.
button: to set the time of the day.
N.B. the ow of co ee from the basket is interrupted when co ee
pot is removed from the heating plate to let you pour that rst cup
midbrew.
B. To set the time
• Turn the function knob on position.
• Press and hold the HR or MIN buttons until display blinks. Then push
HR or MIN button to scroll through the digits. When the numbers
stop blinking, time is set.
• Note: when the number count passes 12, “PM” will be displayed on
the LCD to set the time from noon to midnight. When there is no
indication, you will set AM times from 0 to noon.
C. No programming
• Fill the reservoir with cold water depending on the desired
number of cups (see height markings inside the reservoir).
• The co ee pot height markings represent the number of cups
obtained. The di erence between this scale and the water reservoir
marks results from the amount of water lost in wetting the grounds.
• Insert a #4 paper lter in the lter holder. Add the desired amount
of ground co ee in the lter. Use one measuring scoop per cup. This
average dose can be adjusted to suit your taste.
• Flip the lid close. Make sure the co ee pot is in its position on the
heating plate before switching the co eemaker on.
• Select co ee strength by pressing the
button for regular co ee
or
button for bold co ee.
• Turn the function knob to
.
N.B. For fewer than 5 cups, turn the function knob to
then push
.
• Press
. The red indicator light illuminates and the brewing cycle
starts. The end of brewing cycle is signalled by 5 beep sounds.
• Press
to switch the unit o . The red indicator light goes o .
D. Automatic programming
• Turn the function knob to PROG. The numbers blink 5 times then
stop.
• Press and hold the HR or MIN buttons until display blinks. Then push
HR or MIN button to scroll through the digits. When the numbers
stop blinking, time is set.
• Turn the function knob to AUTO OFF. The numbers blink 5 times
then stop.
• Press and hold the HR or MIN buttons until display blinks. Then push
HR or MIN button to scroll through the digits. When the numbers
stop blinking, time is set.
N.B. The maximum duration for co ee maker to shut o is 38 minutes.
• Turn the function knob to AUTO ON. The current time is now
displayed.
N.B. For fewer than 5 cups, turn the function knob to
then push
.
• Select co ee strength by pressing the
button for regular co ee
or
button for bold co ee.
• Press
to engage the automatic programming. The button is
switched o and the AUTO ON button is switched on.
• At the programmed time, the brewing cycle starts and the red
indicator light will come on.
E. Automatic descaling
Use after use, scaling builds up. Scaling interfers with ne
mechanics and gives co ee a hard and bitter taste. That is why
the appliance should be regularly descaled to ensure good
quality co ee. The descaling frequency depends upon the
hardness of your tap water and how often you use the co emaker.
• When the co eemaker needs descaling, the descaling indicator light
next to the
button begins to ash when the co ee is turned on.