2. Innovative Design Works
  3. PTS-04-UNIV
PTS-04-UNIV

Innovative Design Works PTS-04-UNIV Installation guide

  • Hello! I have reviewed the provided installation instructions for the PTS-04-UNIV payment terminal mount. This document includes key instructions on cable routing, rotation adjustment using stop screws, and tilt friction adjustments. I am ready to answer your questions about the device.
  • How do I determine cable routing prior to installing mount?
    How do I adjust the rotation of the payment terminal?
    How to prevent the payment terminal from rotating?
    How to release the mount?
    How do I adjust the tilt friction?
© 2021 Innovative Ergonomic Solutions REV A
PTS-04-UNIV
Installation Instructions
Innovative Ergonomic Solutions
800 524 2744
customerservice@team-ies.com
team-ies.com
PAGE 1 OF 8
A T20 L-Key 1x
714997
B T25 L-Key 1x
714899
C 4mm Hex Key 1x
709877
PTS-04-UNIV
Installation Instructions
PAGE 2 OF 8
Optional grommet
hole for routing
cables below
mounting surface.
Mounting hardware
not included.
Use appropriate
hardware for your
mounting surface.
For above surface
cable routing, route
the cable prior to
installing the mount.
i
IM PORTANT:
Determine cable routing prior to
installing mount. This will ensure
the mount is installed in the correct
orientation for your installation.
Above Surface Cable Routing
Locate the mount cable exit and plan
your installation accordingly.
Below Surface Cable Routing
Cables may pass through the mount
(requires grommet hole).
Cable
Entry
Cable
Entry
Cable
Exit
Cable
Exit
1
PAGE 3 OF 8
Placement of the two rotation stop screws in
the outer ring determine the amount of payment
terminal rotation. You can remove the screws
from their original location and place them in
any of the holes in the outer ring to allow for the
amount of desired rotation.
There are rotation stop ribs underneath the
top portion of the mount that can be placed
directly over the rotation stop screw or pin.
This positioning will prevent the payment
terminal from rotating. Determine the proper
rotation stop screw location for your installation.
iROTATION STOP
CONFIGURATION
EXAMPLES
OR
ROTATION NO ROTATION
Rotation Stop Ribs
Place this area over
the rotation stop
screw or pin to
prevent the mount
from rotating.
Rotation
Stop Screw
iNO ROTATION
CONFIGURATION
EXAMPLES
Rotation
Stop Screw
Rotation
Stop Screw
2
Rotation
Stop Pin
T20 T20
PAGE 4 OF 8
iHOW TO RELEASE MOUNT
Locate the release tab inside the mount.
Using a screwdriver, or similar tool, pull back
on the tab. With the tab pulled back, lift up on
the upper portion of the mount to release.
Release Tab
When placing the top of the mount onto
the base, ensure the rotation stop ribs
fall in between the rotation stops that
were set in place in Step 2.
Or in a no rotation conguration, the ribs
must be placed over top the rotation
stop screw or pin.
3
PAGE 5 OF 8
4a
4b
T25
T25
PAGE 6 OF 8
iCLAMP POSITIONS
Clamps can be attached to the various
slots shown below to accommodate a
variety of payment terminals.
5
4mm
4mm
PAGE 7 OF 8
OR
iADJUSTMENT FEATURE
To adjust the tilt friction, remove the hex nut covers
and tighten or loosen the 13mm hex nut while securing
the pivot screw on the inside of the mount with a
14mm wrench. Adjust both sides as needed.
6
13mm
14mm
PAGE 8 OF 8
/