Everbilt HDEFR50W User guide

Effluent Pump

Quick Reference Guide

See instruction manual for

complete instructional details.

1. Ensure basin is clear of all debris and place pump on hard level

surface (not dirt or gravel). 30” x 18” minimum basin requirement.

2. Measure, cut and install discharge fittings, check valve, and piping.

Drill a 1/8” hole in the discharge pipe about 2“-3” above the pump

discharge connection.

3. Plug Pump in to GFCI outlet on dedicated circuit with 15 amp

breaker

4. Test operation by filling the basin above the Float Switch Operation

ON Height to make the pump start pumping out. When the water

reaches below the Float Switch Operation OFF Height, ensure it

stops pumping.

5. Install optional basin cover.

18” Minimum

30” Minimum

1/8” Vent Hole

Check Valve

2” Discharge Pipe GFCI Outlet

ON Height:17”

OFF Height:9.91”

EB-0040-rev 10/2021