Acura Collision Mitigation Braking System Operating instructions

Category
Radar detectors
Type
Operating instructions

Acura Collision Mitigation Braking System is designed to assist drivers in avoiding or reducing the severity of frontal collisions. It uses radar and camera sensors to detect vehicles and pedestrians in front of the car, and can apply the brakes automatically if a collision is imminent. The system can also provide visual and audible warnings to alert the driver to potential hazards. It can operate at speeds of up to 20 mph when following another car or up to 50 mph when there is no car ahead.

Acura Collision Mitigation Braking System is designed to assist drivers in avoiding or reducing the severity of frontal collisions. It uses radar and camera sensors to detect vehicles and pedestrians in front of the car, and can apply the brakes automatically if a collision is imminent. The system can also provide visual and audible warnings to alert the driver to potential hazards. It can operate at speeds of up to 20 mph when following another car or up to 50 mph when there is no car ahead.

Quick Reference Guide
AcuraWatchTM (P490)
AcuraWatchTM is a driver support system
which employs the use of two distinctly
different kinds of sensors, a radar sensor
located behind the emblem, and a front
sensor camera mounted to the interior side
of the windshield, behind the rearview
mirror.
AcuraWatchTM is a driver support system
which employs the use of three distinctly
different kinds of sensors, a radar sensor
located behind the emblem, a front sensor
camera mounted to the interior side of the
windshield, behind the rearview mirror, and
the sonar sensors located in the front and
rear bumpers.
Models without Low Speed Braking Control
Models with Low Speed Braking Control
All models
The camera is located
behind the rearview
mirror.
The radar sensor is
behind the emblem.
Front Sensor
Camera
Radar Sensor
Models with Low Speed Braking Control
Sonar Sensors
Collision Mitigation
Braking SystemTM
(CMBSTM) (P495)
The system can assist you when it
determines there is a possibility of your
vehicle colliding with a vehicle or a
pedestrian detected in front of your vehicle.
The CMBSTM is designed to alert you when
the potential for a collision is determined, as
well as to reduce your vehicle speed to help
minimize collision severity when a collision is
deemed unavoidable.
Low Speed Braking
Control* (P506)
Using sonar sensors located on the front and
rear bumpers, this system can detect if there
is danger of a potential collision with a wall
or other obstacle during normal driving or
when the accelerator pedal is depressed
with too much force. The system then assists
in avoiding collisions and reducing damage
from impact through assistive braking and/
or assistive driving power suppression.
23 ACURA MDX-31TYA6100.book 24 ページ 2022年2月4日 金曜日 午前10時25分
Driving
AcuraWatchTM
AcuraWatchTM is a driver support system which employs the use of two distinctly
different kinds of sensors, a radar sensor located behind the emblem, and a front
sensor camera mounted to the interior side of the windshield, behind the rearview
mirror.
AcuraWatchTM is a driver support system which employs the use of three distinctly
different kinds of sensors, a radar sensor located behind the emblem, a front sensor
camera mounted to the interior side of the windshield, behind the rearview mirror,
and the sonar sensors located in the front and rear bumpers.
AcuraWatchTM has the following functions.
The functions which do not require switch operations to activate
Collision Mitigation Braking SystemTM (CMBSTM) 2 P. 495
Low Speed Braking Control* 2 P. 506
Road Departure Mitigation System 2 P. 550
Traffic Sign Recognition System 2 P. 556
The functions which require switch operations to activate
Adaptive Cruise Control (ACC) with Low Speed Follow 2 P. 512
Lane Keeping Assist System (LKAS) 2 P. 529
Traffic Jam Assist 2 P. 538
Models without Low Speed Braking Control
* Not available on all models
23 ACURA MDX-31TYA6100.book 490 ページ 2022年2月4日 金曜日 午前10時25分
uuAcuraWatchTMu
Driving
Button
Press to activate standby mode for ACC with
Low Speed Follow and Traffic Jam Assist. Or
press to cancel these systems.
LKAS Button
Press to activate standby mode for LKAS and
Traffic Jam Assist. Or press to cancel these
systems.
Interval Button
Press to change the ACC with Low Speed
Follow following-interval.
CANCEL Button
Press to cancel ACC with Low Speed Follow.
RES/+/SET/− Switch
Press the RES/+/SET/– switch up to set or
resume the ACC with Low Speed Follow or
increase the vehicle speed.
Press the RES/+/SET/– switch down to set the
ACC with Low Speed Follow or decrease the
vehicle speed.
Operation Switches for the ACC with Low Speed Follow/
LKAS/Traffic Jam Assist
Interval
Button
LKAS
Button
Button
CANCEL
Button
RES/+/SET/−
Switch
23 ACURA MDX-31TYA6100.book 491 ページ 2022年2月4日 金曜日 午前10時25分
uuAcuraWatchTMu
Driving
You can see the current state of ACC with Low Speed Follow, LKAS and Traffic Jam Assist.
When both of a and b indicates, Traffic Jam Assist is ready to be activated.
Gauge Content
6
6
7
aIndicates that ACC with Low Speed Follow is ready to be activated.
White: The system is in standby.
Green: The system is on.
Amber: There is a problem with the system.
bIndicates that LKAS is ready to be activated.
White: The system is in standby.
Green: The system is on.
Amber: There is a problem with the system.
23 ACURA MDX-31TYA6100.book 492 ページ 2022年2月4日 金曜日 午前10時25分
uuAcuraWatchTMu
Driving
You can have the head-up display show you the current state of each function.
2Head-Up Display* P. 125
cIndicates that LKAS or Traffic Jam Assist is activated and whether or not traffic
lane lines are detected.
Solid line: The system is on.
Lane outline: The system is in standby.
dIndicates whether or not ACC with Low Speed Follow detected the vehicle ahead.
eShows vehicle set speed in ACC with Low Speed Follow.
fShows set vehicle interval in ACC with Low Speed Follow.
gIndicates that ACC with Low Speed Follow shows the setting status.
Green: The system is on.
Outlined: The system is not activated.
Models with Head-up display
* Not available on all models
23 ACURA MDX-31TYA6100.book 493 ページ 2022年2月4日 金曜日 午前10時25分
uuAcuraWatchTMu
Driving
To activate ACC with Low Speed Follow, LKAS, and Traffic Jam Assist, carry out the following steps:
How to Operate the Buttons on the Steering Wheel
Press the Button
Button
RES/+/SET/
Switch
LKAS Button
ACC with Low Speed
Follow
The vehicle icon,
interval bars and set
speed appear on the
gauge.
Press the
LKAS
Button
Press the
RES/+/SET/−
Switch down
Press the LKAS
Button
Traffic Jam Assist
Keep your vehicle near the center of the lane while
driving.
Keep vehicle speed under 45mph (72 km/h).
Lane outlines appear on the
gauge.
Traffic Jam Assist is ready to
use.
The lane outlines change to
solid ones once the system
starts operating after
detecting the left and right
lane markings.
LKAS
Keep your vehicle near the center of the lane while driving.
Keep vehicle speed over 45mph (72 km/h).
Lane outlines appear on the
gauge. LKAS is activated.
The lane outlines change to solid
ones once the system starts
operating after detecting the left
and right lane markings.
Press the button, and then press
the RES/+/SET/− Switch down
(white)
(green) (white)
(green)
23 ACURA MDX-31TYA6100.book 494 ページ 2022年2月4日 金曜日 午前10時25分
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Acura Collision Mitigation Braking System Operating instructions

Category
Radar detectors
Type
Operating instructions

Acura Collision Mitigation Braking System is designed to assist drivers in avoiding or reducing the severity of frontal collisions. It uses radar and camera sensors to detect vehicles and pedestrians in front of the car, and can apply the brakes automatically if a collision is imminent. The system can also provide visual and audible warnings to alert the driver to potential hazards. It can operate at speeds of up to 20 mph when following another car or up to 50 mph when there is no car ahead.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI