soundskins SSK-GLDTR4DR Operating instructions

Brand
soundskins
Model
SSK-GLDTR4DR
Type
Operating instructions
Jeep Door Kit Instructions
1. Start by locating the fastening hardware on the door
panel, take the appropriate screw driver and remove.
2. Once all the screws are removed you can take off the
door panel gently watching that you don’t break any of the
clips or mounting hardware. Pull the panel away slowly and
unplug any electrical connections.
3. You will find an insert that needs to be removed, with
mounting screws and cables that control door handle and
locking mechanism. Slowly pull the insert away and pull
through the cables to give yourself some slack.
R
• Panel/trim tool
• Roller
• Screw driver
• Rubber wedge
• Microber cloth
• Acetone or cleaning solution
• Razor blade
Tools needed for installation:
Soundskins USA
13452 Alondra Blvd, Cerritos, Ca 90703
Phone: 877.211.5597
Email: team@soundskinsglobal.com
www.SoundSkinsGlobal.com
4. Next you need to prop the window up by either a rubber
wedge or simply put a screw driver through the bottom hole
as illustrated.
6. When the surface is dry and clean, locate the piece of the
kit with the label on the back that coincides with the door you
are working on. Make sure it lines up correctly before pulling
the white cover paper off. After you confirm the right piece, pull
off the backing paper and start placing the material at the top,
working your way down with a roller. Make sure that the
material is rolled down completey and no air is trapped. Use a
razor blade point or household needle to release any air.
Repeat these steps for all door panels.
5. Now you are ready to prep the metal surface using a
microfiber cloth, Acetone (use a breathing mask), and wipe
away any moisture, oil, debris or etc. Then let air dry for an
appropriate time. The point is to get the surface clean to
ensure material glue contact.
YOU’RE NOW READY TO HIT THE ROAD!
Recommended Installation Instructions
A. Prepping the Surface
After removing interior door panels you are ready to clean the metal areas that will be insulated. If the metal
has “new” look without imperfections then take a microfiber cloth and wipe away any dust and debris. If the metal
is showing signs of age like rust then we recommend using Acetone with a breathing mask to wipe off debris and
loose particles. A shop vacuum might be needed to remove loose debris on the floorboard.
B. Installing Panels
Now that you have a clean surface you are ready to start applying the sheets. We recommend a roller to release
air pockets that might be lingering from trapped air. You want to make sure that you have rolled those out to the
edge and all the material has a good seal to the metal surface. Make sure all pieces are installed and inspected
before reinstalling the interior.
1) Driver Front Door Panel 2,3,4) Driver Rear Door Panel
5) Passenger Front Door Panel 6,7,8) Passenger Rear Door Panel
8 Piece Custom Cut PRO KIT
2020+
4
3
1
2
8
7
6
5
INSTALLATION VIDEO
Scan code
for “how to”
video!
SKU: SSK-GLDTR4DR
  • Page 1 1
  • Page 2 2
  • Page 3 3

soundskins SSK-GLDTR4DR Operating instructions

Brand
soundskins
Model
SSK-GLDTR4DR
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents