2. soundskins
  3. sedan
sedan

soundskins sedan Operating instructions

  • Hello! I have reviewed the instructions provided for the soundskins Custom Cut PRO KIT 4 Piece Door Kit. This document outlines the steps for installing the sound deadening material on your sedan doors, including panel removal, surface preparation and material application . I'm ready to answer any questions you may have about the installation process and this product.
  • What tools are needed for installation?
    How do I remove the door panel?
    How do I prepare the surface for the sound deadening material?
Sedan Door Kit Instructions
1. Start by locating the fastening hardware on the door
panel. Take the appropriate screw driver and remove.
Once all the screws are removed you can take off the
door panel gently using a panel tool, watching that you
don’t break any of the clips or mounting hardware.
2. Pull the panel away slowly and unplug any electrical
connections.
3. Now you are ready to prep the metal surface using a
microfiber cloth and Acetone (or other cleaning solution).
Wipe away any moisture, oil, debris, etc. Then, let it air
dry for an appropriate time. The point is to get the
surface clean to ensure material glue contact.
R
• Panel/trim tool
• Roller
• Screw driver
• Microber cloth
• Acetone or cleaning solution
• Razor blade
Tools needed for installation:
SoundSkins USA
13452 Alondra Blvd, Cerritos, Ca 90703
Phone: 877.211.5597
Email: team@soundskinsglobal.com
www.SoundSkinsGlobal.com
5. Locate the piece of the kit with the label on the back
that coincides with the door you’re working on. Make
sure it lines up and is correct before you pull the white
cover paper off. After you confirm the right piece, pull off
the white paper and use a roller to apply the material at
the top and work your way down. Use a razor blade or
household needle to release air. Repeat for all door
panels.
6. Now you are ready to place the door panel back on
your door. All necessary openings will be available after
you have applied the SoundSkins material. Secure your
door panels with all screws and enjoy your quiet new
ride!
YOU’RE NOW READY TO HIT THE ROAD!
Recommended Installation Instructions
A. Prepping the Surface
After removing interior door panels you are ready to clean the metal areas that will be insulated. If the metal
has “new” look without imperfections then take a microfiber cloth and wipe away any dust and debris. If the metal
is showing signs of age like rust then we recommend using Acetone with a breathing mask to wipe off debris and
loose particles. A shop vacuum might be needed to remove loose debris on the floorboard.
B. Installing Panels
Now that you have a clean surface you are ready to start applying the sheets. We recommend a roller to release
air pockets that might be lingering from trapped air. You want to make sure that you have rolled those out to the
edge and all the material has a good seal to the metal surface. Make sure all pieces are installed and inspected
before reinstalling the interior.
1) Driver Front Door Panel 3) Passenger Front Door Panel
2) Driver Rear Door Panel 4) Passenger Rear Door Panel
4 Piece Custom Cut PRO KIT
2018+
13
4
2
/