BRExhaust 2000-2004 Toyota Avalon 3.0L Operating instructions

Type
Operating instructions
INSTALLATION INSTRUCTIONS | PART NO. 106-0308
BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
Technical Support: 1-800-631-7271
When working on, under, or around any vehicle exercise cauon.
Please allow the vehicle's exhaust system to cool before removal, as
exhaust temperatures may cause severe burns. If working without a
li, always consult vehicle manual for correct liing specicaons.
Always wear safety glasses and ensure a safe work area. Serious injury
or death could occur if safety measures are not followed.
WARNING:
BRExhaust recommends
professional installaon
for all products
www.brexhaust.com
STEP 1:
(Carefully read all instrucons before installaon) Disconnect the
vehicles baery before removal of the OEM exhaust system. This
will prevent electrical accidents and will reset the computer if it
applies to the vehicle. Remove exisng exhaust system from the
vehicle. Only remove parts that will be replaced. Clean exisng
ange with a wire brush to ensure proper sealing.
STEP 2:
Aach item 3 to exisng exhaust and isolators with items 1 and 2
STEP 3:
Ensure new exhaust is not contacng any poron of the
underbody of the vehicle or drivetrain.
STEP 4:
Tighten all clamps starng from rear of the vehicle. (DO NOT
EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL
CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)
BILL OF MATERIALS:
1. 167860
2. 167587
3. 168248
3
2
1
  • Page 1 1

BRExhaust 2000-2004 Toyota Avalon 3.0L Operating instructions

Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI